2007 Ford Escape Alarm Wires
Find the right alarm wire colors, locations, and polarity with this 2007 Ford Escape alarm wiring diagram. This will help you install your car alarm wiring correctly.
Application | Wire Color and Location |
---|---|
Battery Constant Power 12v+ Wire (+) | Tan/Light Blue |
Battery Constant Power 12v+ Wire Location | At Ignition Switch Harness |
Ignition Wire (+) | Light Green/Purple |
Ignition Wire Location | At Ignition Switch Harness |
Second Ignition Wire (+) | N/A |
Second Ignition Wire Location | N/A |
Accessory Wire (+) | Black/Light Green |
Accessory Wire Location | At Ignition Switch Harness |
Second Accessory Wire (+) | N/A |
Second Accessory Wire Location | N/A |
Starter Wire (+) | Tan/Light Blue |
Starter Wire Location | At Ignition Switch Harness |
Ground Wire | Chassis |
2007 Ford Escape Alarm Sensor Wires
Find the right alarm sensor wire colors, locations, and polarity with this 2007 Ford Escape alarm sensor wire chart. This will help you connect all your car alarm sensors correctly.
Application | Wire Color and Location |
---|---|
Brake Light Wire (+) | Light Green |
Brake Light Wire Location | At Switch Above the Brake Pedal |
Dome Light Supervision Wire | Use Door Trigger |
Dome Light Supervision Wire Location | N/A |
Door Trigger Wire (-) | Pink |
Door Trigger Wire Location | At SJB Module (Smart Junction Block) located at the fuse/relay box on the passenger side of the center console. |
Hood Pin Switch Wire (-) | N/A |
Hood Pin Switch Wire Location | N/A |
Horn Wire (-) | Yellow/Light Green |
Horn Wire Location | At SJB Module (Smart Junction Block) located at the fuse/relay box on the passenger side of the center console. |
Key Sense Wire (+) | N/A |
Key Sense Wire Location | N/A |
Parking Light Wire (-) | White/Black |
Parking Light Wire Location | At SJB Module (Smart Junction Block) located at the fuse/relay box on the passenger side of the center console. |
Power Door Lock Wire (-) | Pink/White |
Power Door Lock Wire Location | At SJB Module (Smart Junction Block) located at the fuse/relay box on the passenger side of the center console. |
Power Door Unlock Wire (-) | Same Wire as Door Lock. This vehicle is a 1-wire door locking system. Lock requires a negative trigger through a 1000 ohm resistor and unlock requires a straight negative (-). Some units will also require 2 extra relays. |
Power Door Unlock Wire Location | At SJB Module (Smart Junction Block) located at the fuse/relay box on the passenger side of the center console. |
Tachometer Wire (-) | Not Red or White/Red |
Tachometer Wire Location | At Any Fuel Injector |
Trunk Pin Switch Wire (-) | N/A |
Trunk Pin Switch Wire Location | N/A |
Trunk Release Wire (-) | N/A |
Trunk Release Wire Location | N/A |
Factory Alarm Arm Wire (-) | N/A |
Factory Alarm Arm Wire Location | N/A |
Factory Alarm Disarm Wire (-) | Dark Blue/Light Green |
Factory Alarm Disarm Wire Location | At SJB Module (Smart Junction Block) located at the fuse/relay box on the passenger side of the center console. |
Factory Anti-Theft System | Ford Transponder Anti-Theft System |
Factory Anti-Theft System Location | Requires Immobilizer Bypass Module |
Factory Immobilizer Bypass | Requires Interface Bypass Module |
Feel free to use any 2007 Ford Escape alarm wiring diagram that is listed here but keep in mind that all information here is provided as is without any warranty of any kind. Use of this 2007 Ford Escape car alarm wire chart is at your own risk. Always verify all wires, wire colors and connection points before applying any information found here to your 2007 Ford Escape.
2 thoughts on “2007 Ford Escape Car Alarm Wiring Diagram”
Luisito, it sounds like the battery in your remote is low on battery. Replace the battery in your 2007 Ford Escape remote and the ability to unlock and lock your car from far away will be restored. Hope this helps. Good luck with your 2007 Ford Escape alarm remote battery replacement.
i have 2009 escape and lately to unlock the door remotely, i have to bring the remote very close
to the driver window before it unlocks, where it doesnt serve it’s purpose. Now i wanted to replaced
the alarm module but i cant find it. Where the module is located and how does it look like. thanks, luie.