Updated: 06/26/2024 • Published: 02/27/2012
2008 Chevrolet Malibu Alarm Wires
Find the right alarm wire colors, locations, and polarity with this 2008 Chevrolet Malibu alarm wiring diagram. This will help you install your car alarm wiring correctly.
Application | Wire Color and Location |
---|---|
Battery Constant 12v+ Positive Wire (+) | Red/White |
Battery Constant 12v+ Positive Wire Location | Ignition Switch Harness |
Starter Positive Wire (+) | Violet |
Starter Positive Wire Location | Ignition Switch Harness |
Second Starter Positive Wire (+) | White |
Second Starter Positive Wire Location | Ignition Switch Harness |
Ignition Positive Wire (+) | Pink |
Ignition Positive Wire Location | Ignition Switch Harness |
Second Ignition Positive Wire (+) | N/A |
Second Ignition Positive Wire Location | N/A |
Third Ignition Positive Wire (+) | N/A |
Third Ignition Positive Wire Location | N/A |
Accessory Positive Wire (+) | Brown |
Accessory Positive Wire Location | Ignition Switch Harness |
Second Accessory Positive Wire (+) | White |
Second Accessory Positive Wire Location | Ignition Switch Harness |
Key Sense Wire | N/A |
Key Sense Wire Location | N/A |
2008 Chevrolet Malibu Alarm Sensor Wires
Find the right alarm sensor wire colors, locations, and polarity with this 2008 Chevrolet Malibu alarm sensor wire chart. This will help you connect all your car alarm sensors correctly.
Application | Wire Color and Location |
---|---|
Parking Light Negative Wire (-) | N/A |
Parking Light Negative Wire Location | N/A |
Parking Light Positive Wire (+) | Brown |
Parking Light Positive Wire Location | At BCM Module Under the Right Side of the Center Console |
Power Door Lock Negative Wire (-) | White |
Power Door Lock Negative Wire Location | At BCM Module Under the Right Side of the Center Console |
Power Door Unlock Negative Wire (-) | White (Use a 1.5K ohm resistor) |
Power Door Unlock Negative Wire Location | At 18-Pin Connector in Driver Kick Panel |
Door Trigger Negative Wire (-) | Gray (To avoid domelight delay use individual door triggers and diode isolate each wire.) |
Door Trigger Negative Wire Location | At BCM Module Under the Right Side of the Center Console |
Dome Light Supervision Wire (-) | Gray |
Dome Light Supervision Wire Location | At BCM Module Under the Right Side of the Center Console |
Trunk Trigger Negative Wire (-) | Orange/Black |
Trunk Trigger Negative Wire Location | At BCM Module Under the Right Side of the Center Console |
Trunk Release Negative Wire (-) | N/A |
Trunk Release Negative Wire Location | N/A |
Sliding Power Door Wire | N/A |
Sliding Power Door Wire Location | N/A |
Horn Negative Wire (-) | Tan |
Horn Negative Wire Location | At BCM Module Under the Right Side of the Center Console |
Tachometer Wire Negative Wire (-) | N/A |
Tachometer Wire Negative Wire Location | N/A |
Wait To Start Wire | N/A |
Wait To Start Location | N/A |
Brake Light Positive Wire (+) | White |
Brake Light Positive Wire Location | At BCM Module Under the Right Side of the Center Console |
Factory Alarm Arm Wire (-) | N/A |
Factory Alarm Arm Wire Location | N/A |
Factory Alarm Disarm Wire (-) | N/A |
Factory Alarm Disarm Wire Location | N/A |
Factory Anti-Theft System | GM Passkey III Vehicle Key Immobilizer |
Factory Anti-Theft System Location | Key Sends RF Signal to the BCM Module |
Feel free to use any 2008 Chevrolet Malibu alarm wiring diagram that is listed here but keep in mind that all information here is provided as is without any warranty of any kind. Use of this 2008 Chevrolet Malibu car alarm wire chart is at your own risk. Always verify all wires, wire colors and connection points before applying any information found here to your 2008 Chevrolet Malibu.