2001 Dodge Dakota Car Alarm Wiring Diagram

  1. All Car Makes
  2. »
  3. Dodge Alarm Wiring Diagrams
  4. »
  5. 2001 Dodge Dakota Car Alarm Wiring Diagram


Whether your an expert Dodge Dakota car alarm installer, Dodge Dakota performance fan or a novice Dodge Dakota enthusiast with a 2001 Dodge Dakota, a Dodge Dakota car alarm wiring diagram can save yourself a lot of time. One of the most time consuming tasks with installing an after market car alarm, car security, car remote start, automatic remote starter, shock sensor, tilt sensor, car alarm sensor or any auto alarm is identifying the correct color car security wires for a 2001 Dodge Dakota headlight bulb size you need for your low beam or high beam and save time. Also, find your other car light bulb sizes including your fog light, reverse light, turn signal, brake light and more. It’s that easy!

The Modified Life staff has taken all its Dodge Dakota car alarm wiring diagrams, Dodge Dakota car security wiring diagrams, Dodge Dakota car alarm wire diagrams, Dodge Dakota car security wiring schematics, Dodge Dakota car security diagrams, Dodge Dakota remote starter wiring diagrams and cataloged them online for our visitors to use for free. Our automotive wiring diagrams allow you to enjoy your new auto security electronics rather than spend countless hours trying to figure out which wires goes where.

Feel free to use any Dodge Dakota auto alarm wiring diagram that is listed on Modified Life but keep in mind that all information here is provided “as is” without any warranty of any kind and most of the auto security wiring diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2001 Dodge Dakota.

Questions

If you have any questions pertaining to the car wiring in a 2001 Dodge Dakota, please feel free to post it at the bottom of this page and either we’ll do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you are looking for.

Request a Car Alarm Wiring Diagram

If you can’t find your car alarm wiring, car security wire diagram or auto alarm wire diagram on Modified Life, please feel free to post a car alarm wiring diagram request on this page and we’ll do our best to find you the diagram, schematic or information you need for your mobile security installation.

Adding More Information

If you would like to help the Modified Life community by adding a car security wire schematic, car alarm wire diagram, car remote starter wire diagram, auto remote starter wire diagram or auto security wire diagram to our resource, please feel free to post any additional car wiring information about the 2001 Dodge Dakota on this page.

2001 Dodge Dakota Car Alarm Wiring Diagram

Battery Constant 12v+ Positive Wire (+): Pink/Black and Red/Light Blue
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness

Starter Positive Wire (+): Yellow (16 Gauge)
Starter Positive Wire Location: Ignition Switch Harness

Ignition Positive Wire (+): Dark Blue (16 Gauge)
Ignition Positive Wire Location: Ignition Switch Harness

Second Ignition Positive Wire (+): Dark Green/Red (18 Gauge)
Second Ignition Positive Wire Location: Ignition Switch Harness

Third Ignition Positive Wire (+): Red/White (Requires Relay). The ignition #3 wire must be isolated using a relay to prevent the check engine light from turning on during remote starting.
Third Ignition Positive Wire Location: Ignition Switch Harness

Accessory Positive Wire (+): Black/Orange
Accessory Positive Wire Location: Ignition Switch Harness

Second Accessory Positive Wire (+): Dark Green
Second Accessory Positive Wire Location: Ignition Switch Harness

Parking Light Negative Wire (-): Red/Yellow
Parking Light Negative Wire Location: At CTM (26 Pin Plug, Pin 4). The CTM (central timer module) is located in the drivers kick panel.

Parking Light Positive Wire (+): Black/Yellow
Parking Light Positive Wire Location: At Headlight Switch

Power Door Lock Negative Wire (-): White/Green (1-Wire Door Lock System). This vehicle uses a 1-wire door locking system, lock requires a (-) negative through a 820 ohm resistor and unlock requires a (-)negative through a 330 ohm resistor, some units will also require 2 extra relays.
Power Door Lock Negative Wire Location: At CTM, 16 Pin Plug, Pin 10, See Diagram

Power Door Unlock Negative Wire (-): Same Wire as Above
Power Door Unlock Negative Wire Location: See Diagrams

Door Trigger Negative Wire (-): Tan and Tan/Red (Use Both). The drivers door is a tan (-) at pin 15, the passenger door (and the rear doors if a 4 door) is a tan/red (-) at pin 13. When connecting to an alarm system, use all wires and diode isolate.
Door Trigger Negative Wire Location: At CTM (16 Pin Plug, Pins 15 and 13). The CTM (central timer module) is located in the drivers kick panel.

Domelight Supervision Wire (-): Yellow
Domelight Supervision Wire Location: At CTM (16 Pin Plug, Pin 1). The CTM (central timer module) is located in the drivers kick panel.

Horn Negative Negative Wire (-): Black/Red
Horn Negative Negative Wire Location: At CTM (26 Pin Plug, Pin 5). The CTM (central timer module) is located in the drivers kick panel.

Tachometer Wire Negative Wire (-): On the 2.5L, 3.9L, and 5.9L engines use the black/grey wire at the ignition coil for the tach wire. On the 4.7L engine use the wire that is not a green/orange at the coil.
Tachometer Wire Negative Wire Location: At Coil Pack

Brake Light Positive Wire (+): White/Tan
Brake Light Positive Wire Location: At Switch Above Brake Pedal

Factory Alarm Disarm Wire (-): Light Green/Orange (This wire disarms the vehicle when a (-) negative through a 1565 ohm resistor on this wire will disarm it will also require an extra relay.)
Factory Alarm Disarm Wire Location: At CTM (16 Pin Plug, Pin 14). The CTM (central timer module) is located in the drivers kick panel.

Factory Anti-Theft Wire (-): Chrysler’s Sentry Key (Gray Key Only) A Transponder System
Factory Anti-Theft Wire Location: Transponder At Ignition Switch Tumbler

Leave a Comment

Your email address will not be published. Required fields are marked *

nineteen + seventeen =