1998 Acura Integra Alarm Wires
Find the right alarm wire colors, locations, and polarity with this 1998 Acura Integra alarm wiring diagram. This will help you install your car alarm wiring correctly.
Application | Wire Color and Location |
---|---|
Battery Constant 12v+ Positive Wire (+) | White |
Battery Constant 12v+ Positive Wire Location | Ignition Switch Harness |
Starter Positive Wire (+) | Black/White |
Starter Positive Wire Location | Ignition Switch Harness |
Ignition Positive Wire (+) | Black/Yellow |
Ignition Positive Wire Location | Ignition Switch Harness |
Accessory Positive Wire (+) | Yellow |
Accessory Positive Wire Location | Ignition Switch Harness |
1998 Acura Integra Alarm Sensor Wires
Find the right alarm sensor wire colors, locations, and polarity with this 1998 Acura Integra alarm sensor wire chart. This will help you connect all your car alarm sensors correctly.
Application | Wire Color and Location |
---|---|
Parking Light Positive Wire (+) | Red/Black |
Parking Light Positive Wire Location | At Green Plug Above Fuse Box Or Male Blade Terminal In Fuse Box |
Power Door Lock Negative Wire (-) | Black/White (These wires are in the large of the 2 gray plugs in the lower drivers kick near the firewall. If vehicle is equipped with a cruise control, these plugs are behind this module. You must remove this module to access these plugs. Wires will only test with the passenger door lock switch.) |
Power Door Lock Negative Wire Location | In Drivers Kick Panel |
Power Door Unlock Negative Wire (-) | Black/Red (These wires are in the large of the 2 gray plugs in the lower drivers kick near the firewall. If vehicle is equipped with a cruise control, these plugs are behind this module. You must remove this module to access these plugs. Wires will only test with the passenger door lock switch.) |
Power Door Unlock Negative Wire Location | In Drivers Kick Panel |
Door Trigger Negative Wire (-) | Light Green/Red (May Require Relay) |
Door Trigger Negative Wire Location | In Drivers Kick Panel. This wire is in the larger of the 2 gray plugs in the lower drivers kick near the firewall. If vehicle is equipped with a cruise control, these plugs are behind this module. You must remove this module to access these plugs. This blue tachometer wire is also located in a 16-pin white or gray plug to the left of the fuse box. |
Dome Light Supervision Wire | Use Door Trigger |
Dome Light Supervision Wire Location | N/A |
Trunk Release Negative Wire (-) | Blue (Requires Relay) |
Trunk Release Negative Wire Location | At Hatch Release Switch. The hatch release only operates when the doors are unlocked. |
Horn Negative Negative Wire (-) | Gray (-) Or Blue/Green (-) |
Horn Negative Negative Wire Location | At Steering Column Harness |
Tachometer Wire Negative Wire (-) | Blue |
Tachometer Wire Negative Wire Location | At Tach Test Connector. The tachometer test connector is a 2 pin connector in the drivers side rear corner of the engine compartment. |
Brake Light Positive Wire (+) | Green/White |
Brake Light Positive Wire Location | At Switch Above Brake Pedal |
Factory Alarm Disarm Wire (-) | Disarms With Factory Remote Only. |
Factory Alarm Disarm Wire Location | N/A |
Factory Anti-Theft Wire (-) | N/A |
Factory Anti-Theft Wire Location | N/A |
Feel free to use any 1998 Acura Integra alarm wiring diagram that is listed here but keep in mind that all information here is provided as is without any warranty of any kind. Use of this 1998 Acura Integra car alarm wire chart is at your own risk. Always verify all wires, wire colors and connection points before applying any information found here to your 1998 Acura Integra.
2 thoughts on “1998 Acura Integra Automotive Alarm Wiring Diagram”
Ronnie, here is the stereo adapter you need:
1998 Acura Integra Stereo Wiring Harness Adapter
Hope this helps. Good luck with your 1998 Acura Integra stereo installation.
i need stereo adapter for acura integra 1998