1993 Jeep Wrangler Car Radio Stereo Wiring Diagram

1993 Jeep Wrangler Car Radio Stereo Wiring Diagram

Whether your an expert installer or a novice enthusiast with a 1993 Jeep Wrangler, an car stereo wiring diagram can save yourself a lot of time. One of the most time consuming tasks with installing a car stereo, car radio, car speakers, car amplifier, car navigation or any car electronics is identifying the correct color wires for a 1993 Jeep Wrangler.

The Modified Life staff has taken all its car radio wiring diagrams, car stereo wiring diagrams, car wiring diagrams and cataloged them online. Feel free to use any car stereo wiring diagram that is listed on Modified Life but keep in mind that all information here is provided “as is” without any warranty of any kind and most of the diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 1993 Jeep Wrangler.

If you can’t find your car stereo wiring diagram or car radio wiring diagram on Modified Life, please feel free to post a car wiring diagram request (Car Stereo Wiring Diagram Request Page) and we’ll do our best to find you the information you need for your mobile installation.

If you would like to help the Modified Life community by adding a car stereo wiring diagram or car radio wiring diagram to our resource, please feel free to email us using our contact form.

1993 Jeep Wrangler Car Stereo Radio Wiring Diagram.

Car Radio Constant 12V+ Wire: Red/White
Car Radio Switched 12V+ Wire: Purple/White
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Blue/Red
Car Radio Dimmer Wire: Red/Black
Car Radio Antenna Trigger Wire: N/A
Car Radio Amp Trigger Wire: N/A
Front Speakers Size: 4″ x 6″ Speakers
Front Speakers Location: Dash
Left Front Speaker Wire (+): Gray
Left Front Speaker Wire (-): Yellow
Right Front Speaker Wire (+): White/Red
Right Front Speaker Wire (-): Brown/Red
Rear Speakers Size: 4″ Speakers
Rear Speakers Location: Rear Roof
Left Rear Speaker Wire (+): Gray/White
Left Rear Speaker Wire (-): Brown/White
Right Rear Speaker Wire (+): White/Black
Right Rear Speaker Wire (-): Brown

2 Replies to “1993 Jeep Wrangler Car Radio Stereo Wiring Diagram”

  1. If I just want to replace the two front speakers, how to the wires connect to the speakers? are there ends to the speaker wire that i can just plug in or will i need to solder the wire to the new speakers? can I swap out any 4×6 speakers with the ones that are in my jeep now or will I need special ones?

  2. Luke, you would need to splice or solder on the wires to the new speaker terminals. When choosing speakers to replace your factory speakers, make sure you choose the right impedance (ohm rating) and the correct speaker depth size. The impedance (ohm rating) for the 1993 Jeep Wrangler is 4 ohms. The correct speaker depth size can be found by measuring the speaker from the speaker cone to the magnet. Hope this helps. Good luck with your speaker installation.

Leave a Reply

Your email address will not be published. Required fields are marked *

two × three =