2008 Nissan Versa Auto Alarm Wiring Diagram


Whether your an expert Nissan Versa car alarm installer, Nissan Versa performance fan or a novice Nissan Versa enthusiast with a 2008 Nissan Versa, a Nissan Versa car alarm wiring diagram can save yourself a lot of time. One of the most time consuming tasks with installing an after market car alarm, car security, car remote start, automatic remote starter, shock sensor, tilt sensor, car alarm sensor or any auto alarm is identifying the correct color car security wires for a 2008 Nissan Versa headlight bulb size you need for your low beam or high beam and save time. Also, find your other car light bulb sizes including your fog light, reverse light, turn signal, brake light and more. It’s that easy!

The Modified Life staff has taken all its Nissan Versa car alarm wiring diagrams, Nissan Versa car security wiring diagrams, Nissan Versa car alarm wire diagrams, Nissan Versa car security wiring schematics, Nissan Versa car security diagrams, Nissan Versa remote starter wiring diagrams and cataloged them online for our visitors to use for free. Our automotive wiring diagrams allow you to enjoy your new auto security electronics rather than spend countless hours trying to figure out which wires goes where.

Feel free to use any Nissan Versa auto alarm wiring diagram that is listed on Modified Life but keep in mind that all information here is provided “as is” without any warranty of any kind and most of the auto security wiring diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2008 Nissan Versa.

Questions

If you have any questions pertaining to the car wiring in a 2008 Nissan Versa, please feel free to post it at the bottom of this page and either we’ll do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you are looking for.

Request a Car Alarm Wiring Diagram

If you can’t find your car alarm wiring, car security wire diagram or auto alarm wire diagram on Modified Life, please feel free to post a car alarm wiring diagram request on this page and we’ll do our best to find you the diagram, schematic or information you need for your mobile security installation.

Adding More Information

If you would like to help the Modified Life community by adding a car security wire schematic, car alarm wire diagram, car remote starter wire diagram, auto remote starter wire diagram or auto security wire diagram to our resource, please feel free to post any additional car wiring information about the 2008 Nissan Versa on this page.

2008 Nissan Versa Auto Alarm Wiring Diagram

Battery Constant 12v+ Positive Wire (+): Blue
Battery Constant 12v+ Positive Wire Location: At Ignition Switch Harness

Starter Positive Wire (+): White
Starter Positive Wire Location: At Ignition Switch Harness

Ignition Positive Wire (+): Red
Ignition Positive Wire Location: At Ignition Switch Harness

Accessory Positive Wire (+): Yellow
Accessory Positive Wire Location: At Ignition Switch Harness

Second Accessory Positive Wire (+): Brown
Second Accessory Positive Wire Location: At Ignition Switch Harness

Key Sense Negative Wire (-): Green Or Light Green
Key Sense Negative Wire Location: At Ignition Switch Harness

Parking Light Positive Wire (+): Gray
Parking Light Positive Wire Location: At Drivers Kick Panel, Harness To Rear Of Vehicle

Power Door Lock Negative Wire (-): Gray
Power Door Lock Negative Wire Location: In drivers kick panel or BCM, pin 45, white 15-pin plug. The BCM (body control module) is located behind the glove box.

Power Door Unlock Negative Wire (-): Purple Or Blue
Power Door Unlock Negative Wire Location: In Drivers Kick Panel Or BCM, Pin 46, White 15-Pin Plug. The BCM (Body Control Module) Is Located Behind The Glove Box.

Door Trigger Positive Wire (+): The driver’s door is a light green that turn to brown (-) in pin 47, white 15-pin plug. The passenger door is a is light blue (-), pin 12, white 40-pin plug. The drivers rear door is a white that turns to a orange (-) at pin 48 white 15-pin plug. The passenger rear door is a yellow that turn to gray (-) pin 13, white 40-pin plug. Wire are located in each kick panel or at the BCM behind glove box. When connecting to an alarm system use all 4 wires and diode isolate.
Door Trigger Positive Wire Location: In Each Kick Panel Or BCM, Behind Glove Box

Domelight Supervision Wire (-): Brown
Domelight Supervision Wire Location: At BCM, Black 15-Pin Plug, Pin 63. The BCM (body control module) is located behind the glove box.

Trunk Release Negative Wire (-): Blue Changes To Purple (Test this wire while opening the hatch from the handle on the rear hatch.)
Trunk Release Negative Wire Location: At BCM, White 15-Pin Plug, Pin 53. The BCM (body control module) is located behind the glove box.

Horn Negative Wire (-): Pink Changes To A Red
Horn Negative Wire Location: At Horn Switch In Column

Tachometer Wire Negative Wire (-): Blue
Tachometer Wire Negative Wire Location: At ECM, Gray 32-Pin Plug, Pin 13. The ECM (engine control module) is located on the drivers side strut tower.

Brake Light Positive Wire (+): Red
Brake Light Positive Wire Location: At Switch Above Brake Pedal

Factory Alarm Disarm Wire (-): Brown (Test this disarm wire while turning the key in the driver’s door key cylinder. This wire also unlocks with a double pulse.)
Factory Alarm Disarm Wire Location: In Drivers Kick Panel Or BCM, White 40-Pin Plug, Pin 7.

Factory Anti-Theft System: Nissan’s Transponder Anti-Theft System
Factory Anti-Theft System Location: At Ignition Switch Tumbler

Leave a Reply

Your email address will not be published. Required fields are marked *

seventeen − two =