2006 Chevrolet HHR Alarm Wires
Find the right alarm wire colors, locations, and polarity with this 2006 Chevrolet HHR alarm wiring diagram. This will help you install your car alarm wiring correctly.
| Application | Wire Color and Location |
|---|---|
| Battery Constant 12v+ Positive Wire (+) | Red/Black |
| Battery Constant 12v+ Positive Wire Location | Pin D1 in C3 Connector at BCM Module |
| Ignition Positive Wire (+) | Yellow |
| Ignition Positive Wire Location | Ignition Switch Harness |
| Second Ignition Positive Wire (+) | N/A |
| Second Ignition Positive Wire Location | N/A |
| Third Ignition Positive Wire (+) | N/A |
| Third Ignition Positive Wire Location | N/A |
| Accessory Positive Wire (+) | Brown |
| Accessory Positive Wire Location | Ignition Switch Harness |
| Second Accessory Positive Wire (+) | N/A |
| Second Accessory Positive Wire Location | N/A |
| Starter Positive Wire (+) | Yellow |
| Starter Positive Wire Location | Pin #56 or Pin #46 in Blue Connector at ECM Module |
| Second Starter Positive Wire (+) | N/A |
| Second Starter Positive Wire Location | N/A |
| Key Sense Wire | N/A |
| Key Sense Wire Location | N/A |
2006 Chevrolet HHR Alarm Sensor Wires
Find the right alarm sensor wire colors, locations, and polarity with this 2006 Chevrolet HHR alarm sensor wire chart. This will help you connect all your car alarm sensors correctly.
| Application | Wire Color and Location |
|---|---|
| Parking Light Negative Wire (-) | N/A |
| Parking Light Negative Wire Location | N/A |
| Parking Lights Positive Wire (+) | Brown |
| Parking Lights Positive Wire Location | At Driver Kick Panel |
| Power Door Lock Negative Wire (-) | White |
| Power Door Lock Negative Wire Location | At Driver Kick Panel |
| Power Door Unlock Negative Wire (-) | White (Use a 1.5K Ohm Resistor) |
| Power Door Unlock Negative Wire Location | At Driver Door Harness |
| Door Trigger Negative Wire (-) | Use Latch Wires |
| Door Trigger Negative Wire Location | To avoid domelight delay use individual door triggers and diode isolate each wire. |
| Dome Light Supervision Wire (-) | Gray |
| Dome Light Supervision Wire Location | Pin A10 in Connector C3 at BCM Module |
| Hood Trigger Negative Wire (-) | Pink/Black |
| Hood Trigger Negative Wire Location | Pin #4 in Connector C1 at BCM Module |
| Trunk Trigger Negative Wire (-) | Pink/Black |
| Trunk Trigger Negative Wire Location | Pin #55 in Connector C1 at BCM Module |
| Sliding Power Door Wire | N/A |
| Sliding Power Door Wire Location | N/A |
| Horn Negative Wire (-) | Tan |
| Horn Negative Wire Location | At Steering Column Harness |
| Brake Light Positive Wire (+) | Light Blue |
| Brake Light Positive Wire Location | At Switch Above the Brake Pedal |
| Factory Alarm Disarm Wire (-) | N/A |
| Factory Alarm Disarm Wire Location | N/A |
| Factory Anti-Theft System | Passlock II Key Vehicle Immobilizer |
| Factory Anti-Theft System Type | Key Sends a RF Signal to the BCM Module |
Feel free to use any 2006 Chevrolet HHR alarm wiring diagram that is listed here but keep in mind that all information here is provided as is without any warranty of any kind. Use of this 2006 Chevrolet HHR car alarm wire chart is at your own risk. Always verify all wires, wire colors and connection points before applying any information found here to your 2006 Chevrolet HHR.