2005 Nissan Titan Alarm Wires
Find the right alarm wire colors, locations, and polarity with this 2005 Nissan Titan alarm wiring diagram. This will help you install your car alarm wiring correctly.
| Application | Wire Color and Location |
|---|---|
| Battery Constant 12v+ Positive Wire (+) | Green |
| Battery Constant 12v+ Positive Wire Location | Ignition Switch Harness |
| Starter Positive Wire (+) | Brown (When installing a remote starter, you must use both starter #1 and starter #2 wires. Both wires must be connected to the starter/cranking output wire from the remote starter or the vehicle will not remote start when the engine is cold.) |
| Starter Positive Wire Location | Ignition Switch Harness |
| Second Starter Positive Wire (+) | Light Green Or Blue/Green (When installing a remote starter, you must use both starter #1 and starter #2 wires. Both wires must be connected to the starter/cranking output wire from the remote starter or the vehicle will not remote start when the engine is cold.) |
| Second Starter Positive Wire Location | Ignition Switch Harness |
| Ignition Positive Wire (+) | Black/Red |
| Ignition Positive Wire Location | Ignition Switch Harness |
| Accessory Positive Wire (+) | Red |
| Accessory Positive Wire Location | Ignition Switch Harness |
| Second Accessory Positive Wire (+) | Purple |
| Second Accessory Positive Wire Location | Ignition Switch Harness |
2005 Nissan Titan Alarm Sensor Wires
Find the right alarm sensor wire colors, locations, and polarity with this 2005 Nissan Titan alarm sensor wire chart. This will help you connect all your car alarm sensors correctly.
| Application | Wire Color and Location |
|---|---|
| Parking Light Positive Wire (+) | Red/Blue |
| Parking Light Positive Wire Location | At Dimmer Switch On Dash |
| Power Door Lock Negative Wire (-) | Blue |
| Power Door Lock Negative Wire Location | At Module, Inside Drivers Door |
| Power Door Unlock Negative Wire (-) | Red (Requires a Double Pulse) |
| Power Door Unlock Negative Wire Location | At Module, Inside Drivers Door |
| Door Trigger Negative Wire (-) | The left front door trigger is light blue (-) in pin 47. The right front door trigger is red/blue (-) in pin 12. The left rear door trigger is red/yellow (-) in pin 48. The right rear door trigger is red/white or gray (-) in pin 13. When connecting to an alarm system use all 3 door trigger wires and diode isolate. |
| Door Trigger Negative Wire Location | At BCM. The BCM (body control module) is located to right of the steering column. |
| Dome Light Supervision Wire (-) | Blue |
| Dome Light Supervision Wire Location | At BCM, Pin 63. The BCM (body control module) is located to right of the steering column. |
| Horn Negative Wire (-) | Red/White |
| Horn Negative Wire Location | At Steering Column Harness |
| Tachometer Wire Negative Wire (-) | Any Wire Not White/Blue Or Black |
| Tachometer Wire Negative Wire Location | At Any Ignition Coil |
| Brake Light Positive Wire (+) | Red/Green Or Red/Black |
| Brake Light Positive Wire Location | At Switch Above Brake Pedal |
| Factory Alarm Disarm Wire (-) | Disarms With Unlock, Single Pulse Disarms |
| Factory Alarm Disarm Wire Location | N/A |
| Factory Anti-Theft System | Transponder Anti-Theft System, Requires Bypass Module And Extra Ignition Key |
| Factory Anti-Theft System Location | Transponder At Ignition Switch Tumbler |
Feel free to use any 2005 Nissan Titan alarm wiring diagram that is listed here but keep in mind that all information here is provided as is without any warranty of any kind. Use of this 2005 Nissan Titan car alarm wire chart is at your own risk. Always verify all wires, wire colors and connection points before applying any information found here to your 2005 Nissan Titan.
3 thoughts on “2005 Nissan Titan Car Alarm Wire Chart”
I’m installing an autostart in my 2004 Nissan Titan and I’ve found every wire except the power lock and unlock wires. I went directly to the door and found the red and blue wires listed on this site but they don’t test right, they rest at 5volts and nothing happens when connected to a negative pulse. I believe I’ve tested every wire in the door, can someone please tell me what I’m missing. Thanks
Paul, if you have a factory alarm system, connect the negative terminal and disarm the alarm by putting your key in the driver door keyhole and unlocking the door manually. This will disarm the factory alarm. If you have an aftermarket alarm system, connect the negative terminal and press the unlock button on your remote. This will disarm the aftermarket alarm. If this doesn’t work, you may have to reprogram your remote to your alarm system. The steps to reprogram your remote depends on your alarm system. Our advice would be to take your 2005 Nissan Titan to an experienced alarm installer and have them reprogram the remote. It shouldn’t take more than 10 to 15 minutes. Hope this helps. Good luck with your alarm.
Disconnected the negative terminal of my battery on my 05 Titan as I was away from home for a long period of time. Now as soon as I try to reconnect the terminal the alarm system goes off. How do I shut off the alarm system when I reconnect the terminal to the battery?