Whether your an expert Chevrolet Venture car alarm installer, Chevrolet Venture performance fan or a novice Chevrolet Venture enthusiast with a 2005 Chevrolet Venture, a Chevrolet Venture car alarm wiring diagram can save yourself a lot of time. One of the most time consuming tasks with installing an after market car alarm, car security, car remote start, automatic remote starter, shock sensor, tilt sensor, car alarm sensor or any auto alarm is identifying the correct color car security wires for a 2005 Chevrolet Venture headlight bulb size you need for your low beam or high beam and save time. Also, find your other car light bulb sizes including your fog light, reverse light, turn signal, brake light and more. It’s that easy!
The Modified Life staff has taken all its Chevrolet Venture car alarm wiring diagrams, Chevrolet Venture car security wiring diagrams, Chevrolet Venture car alarm wire diagrams, Chevrolet Venture car security wiring schematics, Chevrolet Venture car security diagrams, Chevrolet Venture remote starter wiring diagrams and cataloged them online for our visitors to use for free. Our automotive wiring diagrams allow you to enjoy your new auto security electronics rather than spend countless hours trying to figure out which wires goes where.
Feel free to use any Chevrolet Venture auto alarm wiring diagram that is listed on Modified Life but keep in mind that all information here is provided as-is without any warranty of any kind and most of the auto security wiring diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2005 Chevrolet Venture.
Questions
If you have any questions pertaining to the car wiring in a 2005 Chevrolet Venture, please feel free to post it at the bottom of this page and either we will do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you are looking for.
Request a Car Alarm Wiring Diagram
If you can not find your car alarm wiring, car security wire diagram or auto alarm wire diagram on Modified Life, please feel free to post a car alarm wiring diagram request on this page and we will do our best to find you the diagram, schematic or information you need for your mobile security installation.
Adding More Information
If you would like to help the Modified Life community by adding a car security wire schematic, car alarm wire diagram, car remote starter wire diagram, auto remote starter wire diagram or auto security wire diagram to our resource, please feel free to post any additional car wiring information about the 2005 Chevrolet Venture on this page.
2005 Chevrolet Venture Auto Alarm Wiring Instructions
Battery Constant 12v+ Positive Wire (+): Red And Red/White
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness
Starter Positive Wire (+): Yellow
Starter Positive Wire Location: Ignition Switch Harness
Second Starter Positive Wire (+): N/A
Second Starter Positive Wire Location: N/A
Ignition Positive Wire (+): Pink
Ignition Positive Wire Location: Ignition Switch Harness
Second Ignition Positive Wire (+): White (This wire must be connected for remote starting.)
Second Ignition Positive Wire Location: Ignition Switch Harness
Third Ignition Positive Wire (+): N/A
Third Ignition Positive Wire Location: N/A
Accessory Positive Wire (+): Orange
Accessory Positive Wire Location: Ignition Switch Harness
Second Accessory Positive Wire (+): N/A
Second Accessory Positive Wire Location: N/A
Key Sense Wire: N/A
Key Sense Wire Location: N/A
Parking Light Negative Wire (-): Brown/White
Parking Light Negative Wire Location: At BCM Module, Blue Plug, Pin D11. The BCM (body control module) is located above the passenger side kick panel.
Parking Light Positive Wire (+): Brown
Parking Light Positive Wire Location: At Headlight Switch Or In Drivers Kick Panel
Power Door Lock Negative Wire (-): Red/Black (Type B). If vehicle does not have factory alarm, use a light blue (-) for lock, and white (-) for unlock these wires are located in either kick panel. If vehicle is equipped with a factory alarm use the red/black (-) for lock and the orange/black (-) these wires will only meter when turning the key in either door key cylinder. You must also program the units door lock pulse length to 3.5 second pulse.
Power Door Lock Negative Wire Location: At BCM Module. The BCM (body control module) is located above the passenger side kick panel.
Power Door Unlock Negative Wire (-): Orange/Black (Type B). If vehicle does not have factory alarm, use a light blue (-) for lock, and white (-) for unlock these wires are located in either kick panel. If vehicle is equipped with a factory alarm use the red/black (-) for lock and the orange/black (-) these wires will only meter when turning the key in either door key cylinder. You must also program the units door lock pulse length to 3.5 second pulse.
Power Door Unlock Negative Wire Location: At BCM Module. The BCM (body control module) is located above the passenger side kick panel.
Door Trigger Negative Wire (-): This vehicle has (3) door trigger wires. The drivers door is a tan (-), passenger door and lift gate is a dark blue (-) and orange (-) for the sliding door(s). When connecting to an alarm system use all 3 wires and diode isolate.
Door Trigger Negative Wire Location: At BCM Module. The BCM (body control module) is located above the passenger side kick panel.
Dome Light Supervision Wire (-): Gray/Black
Dome Light Supervision Wire Location: At BCM Module, Neutral Plug Pin F. The BCM (body control module) is located above the passenger side kick panel.
Trunk Release Negative Wire (-): N/A
Trunk Release Negative Wire Location: N/A
Sliding Power Door Wire (-): Light Blue And Light Blue/Black. A pulse of (-) negative to this light blue (-) right door and the light blue/black (-) left door wire will open the power sliding door and a pulse of (-) negative on the same wire will then close the power sliding door.
Sliding Power Door Wire Location: In Each Kick Panel
Horn Negative Wire (-): Black
Horn Negative Wire Location: At BCM Module. The BCM (body control module) is located above the passenger side kick panel.
Tachometer Wire Negative Wire (-): Purple/White (The tach wire is in the main harness on the drivers side of the engine, on top of the manifold cover.)
Tachometer Wire Negative Wire Location: At Ignition Coils On Engine
Wait To Start Wire: N/A
Wait To Start Location: N/A
Brake Light Positive Wire (+): White
Brake Light Positive Wire Location: At Switch Above Brake Pedal
Factory Alarm Disarm Wire (-): Disarms With Unlock
Factory Alarm Disarm Wire Location: N/A
Factory Anti-Theft System: GM Passkey 3 (PK3 on Steel Shaft Of Ignition Key) Transponder System
Factory Anti-Theft System Location: Transponder At Ignition Switch Tumbler
The 2005 Chevrolet Venture alarm wire color and location information above is updated as it is submitted by the Modified Life community.