2000 Volkswagen Cabrio Car Security Wiring Guide

  1. All Car Makes
  2. »
  3. Volkswagen Alarm Wiring Diagrams
  4. »
  5. 2000 Volkswagen Cabrio Car Security Wiring Guide


Whether your an expert Volkswagen Cabrio car alarm installer, Volkswagen Cabrio performance fan or a novice Volkswagen Cabrio enthusiast with a 2000 Volkswagen Cabrio, a Volkswagen Cabrio car alarm wiring diagram can save yourself a lot of time. One of the most time consuming tasks with installing an after market car alarm, car security, car remote start, automatic remote starter, shock sensor, tilt sensor, car alarm sensor or any auto alarm is identifying the correct color car security wires for a 2000 Volkswagen Cabrio headlight bulb size you need for your low beam or high beam and save time. Also, find your other car light bulb sizes including your fog light, reverse light, turn signal, brake light and more. It’s that easy!

The Modified Life staff has taken all its Volkswagen Cabrio car alarm wiring diagrams, Volkswagen Cabrio car security wiring diagrams, Volkswagen Cabrio car alarm wire diagrams, Volkswagen Cabrio car security wiring schematics, Volkswagen Cabrio car security diagrams, Volkswagen Cabrio remote starter wiring diagrams and cataloged them online for our visitors to use for free. Our automotive wiring diagrams allow you to enjoy your new auto security electronics rather than spend countless hours trying to figure out which wires goes where.

Feel free to use any Volkswagen Cabrio auto alarm wiring diagram that is listed on Modified Life but keep in mind that all information here is provided “as is” without any warranty of any kind and most of the auto security wiring diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2000 Volkswagen Cabrio.

Questions

If you have any questions pertaining to the car wiring in a 2000 Volkswagen Cabrio, please feel free to post it at the bottom of this page and either we’ll do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you are looking for.

Request a Car Alarm Wiring Diagram

If you can’t find your car alarm wiring, car security wire diagram or auto alarm wire diagram on Modified Life, please feel free to post a car alarm wiring diagram request on this page and we’ll do our best to find you the diagram, schematic or information you need for your mobile security installation.

Adding More Information

If you would like to help the Modified Life community by adding a car security wire schematic, car alarm wire diagram, car remote starter wire diagram, auto remote starter wire diagram or auto security wire diagram to our resource, please feel free to post any additional car wiring information about the 2000 Volkswagen Cabrio on this page.

2000 Volkswagen Cabrio Car Security Wiring Guide

Battery Constant 12v+ Positive Wire (+): Red (10 Gauge Wire)
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness

Starter Positive Wire (+): Red/Black (10 Gauge Wire)
Starter Positive Wire Location: Ignition Switch Harness

Ignition Positive Wire (+): Black (16 Gauge Wire)
Ignition Positive Wire Location: Ignition Switch Harness

Accessory Positive Wire (+): Black/Yellow (12 Gauge Wire)
Accessory Positive Wire Location: Ignition Switch Harness

Parking Light Positive Wire (+): Gray/Red and Gray/Black (Use Both). The hidden release tab for the headlight switch is on the upper left side of the switch. You must cut both of the parking light wires and isolate the switch side of the wires with a relay so that the switch does not see (+) 12 volts. You can also use the hazard wires the black/white and black/green these are (+) positive wires and are located at the steering column. Requires (2) relays.
Parking Light Positive Wire Location: At Headlight Switch, See Diagram

Power Door Lock Negative Wire (-): Yellow/Red or Gray
Power Door Lock Negative Wire Location: In Drivers Kick Panel, At Door Harness

Power Door Unlock Negative Wire (-): Red/Black Or Green (Requires Double Pluse)
Power Door Unlock Negative Wire Location: In Drivers Kick Panel, At Door Harness

Door Trigger Negative Wire (-): Brown/White
Door Trigger Negative Wire Location: In Drivers Kick Panel or Alarm Module. The alarm module, is located behind the headlight switch.

Domelight Supervision Wire: Use Door Trigger (Requires Relay)
Domelight Supervision Wire Location: N/A

Trunk Release Positive Wire (+): Gray (Requires Relay). The gray wire is grounded by the hatch release switch at rest, cut this wire in half and use a relay to isolate the switch side of the trunk release wire from seeing (+) 12volts.
Trunk Release Positive Wire Location: At Trunk Release Switch, See Diagram

Horn Negative Positive Wire (+): Black/Yellow
Horn Negative Positive Wire Location: At Alarm Module. The alarm module, is located behind the headlight switch.

Tachometer Wire Negative Wire (-): Black/Red
Tachometer Wire Negative Wire Location: At Ignition Coil

Brake Light Positive Wire (+): Red/Black
Brake Light Positive Wire Location: At Switch Above Brake Pedal

Factory Alarm Disarm Wire (-): Disarms With Unlock, Single Pulse Disarms
Factory Alarm Disarm Wire Location: N/A

Factory Anti-Theft System: Transponder anti-theft system, requires bypass module and extra ignition key. The transponder anti-theft system is only on some 2000 model year vehicles.

Leave a Comment

Your email address will not be published. Required fields are marked *

two + nineteen =