1997 Chevrolet Tahoe Alarm Wires
Find the right alarm wire colors, locations, and polarity with this 1997 Chevrolet Tahoe alarm wiring diagram. This will help you install your car alarm wiring correctly.
| Application | Wire Color and Location |
|---|---|
| Battery Constant 12v+ Positive Wire (+) | Red |
| Battery Constant 12v+ Positive Wire Location | Ignition Switch Harness |
| Starter Positive Wire (+) | Yellow |
| Starter Positive Wire Location | Ignition Switch Harness |
| Ignition Positive Wire (+) | Pink |
| Ignition Positive Wire Location | Ignition Switch Harness |
| Second Ignition Positive Wire (+) | Pink/White (+) Or White (+). This wire must be connected as ignition #2 for remote starting. |
| Second Ignition Positive Wire Location | Ignition Switch Harness |
| Accessory Positive Wire (+) | Orange |
| Accessory Positive Wire Location | Ignition Switch Harness |
1997 Chevrolet Tahoe Alarm Sensor Wires
Find the right alarm sensor wire colors, locations, and polarity with this 1997 Chevrolet Tahoe alarm sensor wire chart. This will help you connect all your car alarm sensors correctly.
| Application | Wire Color and Location |
|---|---|
| Parking Light Positive Wire (+) | Brown |
| Parking Light Positive Wire Location | At Headlight Switch |
| Power Door Lock Negative Wire (-) | Light Blue (Type A). If vehicle is a 2-door, the door locking system is a type “c”, if vehicle is a 4-door, the door locking system is a type “a”. |
| Power Door Lock Negative Wire Location | In Either Door Harness |
| Power Door Unlock Negative Wire (-) | White (Type A). If vehicle is a 2-door, the door locking system is a type “c”, if vehicle is a 4-door, the door locking system is a type “a”. |
| Power Door Unlock Negative Wire Location | In Either Door Harness |
| Door Trigger Negative Wire (-) | Purple |
| Door Trigger Negative Wire Location | At Headlight Switch |
| Dome Light Supervision Wire (-) | White (Requires Relay) |
| Dome Light Supervision Wire Location | At Headlight Switch |
| Trunk Release Positive Wire (+) | Black (+) or Black/White (+). Requires Relay. If the vehicle has a rear light gate it is a (+) positive and if it has rear cargo doors it is a 5 wire system. |
| Trunk Release Negative Wire Location | Low In Passengers Kick Panel |
| Horn Negative Wire (-) | Black (-) |
| Horn Negative Wire Location | At Steering Column Harness |
| Tachometer Wire Negative Wire (-) | White |
| Tachometer Wire Negative Wire Location | At ECM. The ECM (engine control module) is located behind the glove box and to the right. |
| Brake Light Positive Wire (+) | White |
| Brake Light Positive Wire Location | At Switch Above Brake Pedal |
| Factory Alarm Disarm Wire (-) | N/A |
| Factory Alarm Disarm Wire Location | N/A |
| Factory Anti-Theft System | N/A |
| Factory Anti-Theft System Location | N/A |
Feel free to use any 1997 Chevrolet Tahoe alarm wiring diagram that is listed here but keep in mind that all information here is provided as is without any warranty of any kind. Use of this 1997 Chevrolet Tahoe car alarm wire chart is at your own risk. Always verify all wires, wire colors and connection points before applying any information found here to your 1997 Chevrolet Tahoe.
2 thoughts on “1997 Chevrolet Tahoe Security Wiring Diagram”
Tommy, it would be hard to say what could be causing your battery draining problem because there are some many factors to consider. Our advice is to take your 1997 Chevrolet Tahoe to a qualified alarm installer and ask them to troubleshoot your alarm because it does take some wiring experience and alarm installation knowledge. Hope this helps. Good luck on your 1997 Chevrolet Tahoe car alarm troubleshooting.
Thanks for the diagram. Have a 1997 Chevrolet Tahoe 2-door that has after market alarm installed. The alarm does not work and something is draining the battery. The installer is out of business. Any suggestions on how to locate the cause for the drain?