1996 Toyota Tacoma Alarm Wires
Find the right alarm wire colors, locations, and polarity with this 1996 Toyota Tacoma alarm wiring diagram. This will help you install your car alarm wiring correctly.
Application | Wire Color and Location |
---|---|
Battery Constant 12v+ Positive Wire (+) | White |
Battery Constant 12v+ Positive Wire Location | Ignition Switch Harness |
Starter Positive Wire (+) | Black |
Starter Positive Wire Location | Ignition Switch Harness |
Ignition Positive Wire (+) | Black/Yellow |
Ignition Positive Wire Location | Ignition Switch Harness |
Second Ignition Positive Wire (+) | Black/Red |
Second Ignition Positive Wire Location | Ignition Switch Harness |
1996 Toyota Tacoma Alarm Sensor Wires
Find the right alarm sensor wire colors, locations, and polarity with this 1996 Toyota Tacoma alarm sensor wire chart. This will help you connect all your car alarm sensors correctly.
Application | Wire Color and Location |
---|---|
Parking Light Negative Wire (-) | Red/Black |
Parking Light Negative Wire Location | At Steering Column Harness, White Plug |
Parking Light Positive Wire (+) | Green |
Parking Light Positive Wire Location | At Bottom Of Fuse Box |
Power Door Lock Negative Wire (-) | Red/White |
Power Door Lock Negative Wire Location | In Drivers Kick Panel |
Power Door Unlock Negative Wire (-) | Red/Yellow |
Power Door Unlock Negative Wire Location | In Drivers Kick Panel |
Door Trigger Negative Wire (-) | Black/White |
Door Trigger Negative Wire Location | At Top, Rear Of Fuse Box, 2-Pin Plug |
Dome Light Supervision Wire | Use Door Trigger (Requires Relay) |
Dome Light Supervision Wire Location | N/A |
Horn Negative Negative Wire (-) | Green/Red |
Horn Negative Negative Wire Location | At Steering Column Harness |
Tachometer Wire Negative Wire (-) | Black |
Tachometer Wire Negative Wire Location | At Igniter. The igniter, is located on the right side of the engine compartment for the V6, and on the left side, for the 4-cylinder. |
Brake Light Positive Wire (+) | Green/White |
Brake Light Positive Wire Location | At Switch Above Brake Pedal |
Factory Alarm Disarm Wire (-) | N/A |
Factory Alarm Disarm Wire Location | N/A |
Factory Anti-Theft Wire (-) | N/A |
Factory Anti-Theft Wire Location | N/A |
Feel free to use any 1996 Toyota Tacoma alarm wiring diagram that is listed here but keep in mind that all information here is provided as is without any warranty of any kind. Use of this 1996 Toyota Tacoma car alarm wire chart is at your own risk. Always verify all wires, wire colors and connection points before applying any information found here to your 1996 Toyota Tacoma.
4 thoughts on “1996 Toyota Tacoma Car Alarm Wire Chart”
Mary, it sounds like the sensitivity on your shock sensor is set too high. Our advice is to take your car to an experienced alarm installer and have them turn the sensitivity down. Hope this helps. Good luck with your shock sensor adjustment.
Which wire do I yank to disable the car alarm? It goes off every few hours and sometimes when a big truck passes by. It’s driving me, and everyone at work CRAZY!
Phil, remove the driver door sill plastic and try accessing the negative door trigger wire under there. It should be the same color. Hope this helps. Good luck.
I cannot find the negative door trigger wire. I hooked up to the only black/white wire that was behind the fuse box and it didn’t work for me. Any suggestions?