1993 Ford Probe Alarm Wires
Find the right alarm wire colors, locations, and polarity with this 1993 Ford Probe alarm wiring diagram. This will help you install your car alarm wiring correctly.
Application | Wire Color and Location |
---|---|
Battery Constant 12v+ Positive Wire (+) | Black/Blue or Black |
Battery Constant 12v+ Positive Wire Location | Ignition Switch Harness |
Starter Positive Wire (+) | Black/Yellow |
Starter Positive Wire Location | Ignition Switch Harness |
Ignition Positive Wire (+) | Black/Pink |
Ignition Positive Wire Location | Ignition Switch Harness |
Accessory Positive Wire (+) | Blue/Yellow |
Accessory Positive Wire Location | Ignition Switch Harness |
1993 Ford Probe Alarm Sensor Wires
Find the right alarm sensor wire colors, locations, and polarity with this 1993 Ford Probe alarm sensor wire chart. This will help you connect all your car alarm sensors correctly.
Application | Wire Color and Location |
---|---|
Parking Light Negative Wire (-) | Green |
Parking Light Negative Wire Location | At Headlight Switch |
Parking Light Positive Wire (+) | Orange |
Parking Light Positive Wire Location | In Orange Plug, Top Of Fuse Box |
Power Door Lock Negative Wire (-) | Green/Black (1-Wire System). This vehicle is a 1-wire door locking system, to lock requires a straight (+) positive, and to unlock requires a (+) positive through a 4700 ohm resistor, some units will also require 2 extra relays. |
Power Door Lock Negative Wire Location | In Drivers Kick Panel |
Power Door Unlock Negative Wire (-) | Same Wire as Above. This vehicle is a 1-wire door locking system, to lock requires a straight (+) positive, and to unlock requires a (+) positive through a 4700 ohm resistor, some units will also require 2 extra relays. |
Power Door Unlock Negative Wire Location | N/A |
Door Trigger Negative Wire (-) | Red/White |
Door Trigger Negative Wire Location | Low In Drivers Kick Panel |
Dome Light Supervision Wire | Use Door Trigger (Requires Relay) |
Dome Light Supervision Wire Location | N/A |
Horn Negative Negative Wire (-) | Green/Orange |
Horn Negative Negative Wire Location | At Steering Column Harness. The horn wire is in a orange plug with the air bag wires. Do not unplug harness. |
Tachometer Wire Negative Wire (-) | Yellow/Blue |
Tachometer Wire Negative Wire Location | At Ignition Coil |
Brake Light Positive Wire (+) | White/Green |
Brake Light Positive Wire Location | At Switch Above Brake Pedal |
Factory Alarm Disarm Wire (-) | Yellow/Red |
Factory Alarm Disarm Wire Location | At Gray Plug Behind Fuse Box |
Factory Anti-Theft Wire (-) | N/A |
Factory Anti-Theft Wire Location | N/A |
Feel free to use any 1993 Ford Probe alarm wiring diagram that is listed here but keep in mind that all information here is provided as is without any warranty of any kind. Use of this 1993 Ford Probe car alarm wire chart is at your own risk. Always verify all wires, wire colors and connection points before applying any information found here to your 1993 Ford Probe.
2 thoughts on “1993 Ford Probe Automotive Alarm Wiring Diagram”
Trisha, as much as we would like to help you, not all car alarms are installed the same way. Different brands and different setups will call for different wiring. Our advice is to take your car to a qualified alarm installer and ask them to re-install the remote start system because it does take some wiring knowledge and experience to know what to do. Hope this helps. Good luck on your 1993 Ford Probe car alarm removal.
How do i disconnect the alarm to my probe??? I didn’t even know I had one until all of a sudden it decided to go off, can’t get it turned off and is draing battery. Had to pull wire from horn area to disconnect noise???