Car Stereo Radio Wiring Diagram and Wire Colors – 1999 Chrysler Sebring

Whether your an expert installer or a novice enthusiast with a 1999 Chrysler Sebring, an automotive wiring diagram can save yourself time and headaches. One of the most time consuming tasks with installing a car stereo, car radio, car speakers, car amplifier, car navigation or any mobile electronics is identifying the correct wires for a 1999 Chrysler Sebring.

The Modified Life staff has put their heads together to create an invaluable resource containing free car stereo wiring diagram, free car wiring diagram and free radio wiring diagram. Feel free to use any car stereo wiring diagram or factory radio wire colors that are listed on Modified Life but keep in mind that all information here is provided “as is” without any warranty of any kind. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 1999 Chrysler Sebring.

If you can’t find your car radio wiring diagram, factory radio wire colors or stereo wire diagram on Modified Life, please feel free to post a car wiring diagram request (Radio Wiring Diagram Request Page) and we’ll do our best to find you the information you need for your mobile installation.

1999 Chrysler Sebring Car Stereo Radio Wiring Diagram

Radio Constant 12V+ Wire: Red
Radio Ignition Switched 12V+ Wire: Blue
Radio Ground Wire: Black/Yellow
Radio Illumination Dimmer Wire: Green/Yellow
Radio Antenna Trigger Wire: N/A
Radio Amplifier Trigger Wire: N/A
Front Speakers Size: 6 1/2″ Speakers
Front Speakers Location: Doors
Left Front Speaker Wire (+): White/Blue
Left Front Speaker Wire (-): Black/Blue
Right Front Speaker Wire (+): White/Red
Right Front Speaker Wire (-): Black/Red
Rear Speakers Size: 6″ x 9″ Speakers
Rear Speakers Location: Rear Deck
Left Rear Speaker Wire (+): Yellow/Blue
Left Rear Speaker Wire (-): Gray/Blue
Right Rear Speaker Wire (+): Yellow/Red
Right Rear Speaker Wire (-): Gray/Red

Make Your Chrysler Sebring Car Stereo Installation Easy with these Products

2 Comments

  • Reply Mike Cline October 28, 2011 at 5:34 pm

    I have a 1999 Chrysler Sebring radio which indicates it on, even putting in a cassette tape shows the tape running, but no sound comes out of the speakers ? Help !

  • Reply ModifiedLife November 4, 2011 at 12:30 am

    Mike, double check ALL your fuses using an Automotive Fuse Tester because certain vehicles may have a wire tied into another circuit not labeled as car radio. You may have additional fuse boxes by the driver side of the dash, passenger side of the dash, driver kick panel, passenger kick panel, under the steering column or under the hood. If all of your fuses are good, your 1999 Chrysler Sebring factory amplifier (if equipped) may be faulty. We suggest you take your car to an experienced audio installer and have them troubleshoot your problem. Hope this helps. Good luck with your 1999 Chrysler Sebring radio troubleshooting.

  • Leave a Reply

    12 − 5 =