Car Stereo Radio Wiring Diagram – 2005 Hyundai Elantra

Whether your an expert installer or a novice enthusiast with a 2005 Hyundai Elantra, an automotive wiring diagram can save yourself time and headaches. One of the most time consuming tasks with installing a car stereo, car radio, car speakers, car amplifier, car navigation or any mobile electronics is identifying the correct wires for a 2005 Hyundai Elantra.

The Modified Life staff has put their heads together to create an invaluable resource containing car stereo wiring diagram, car wiring diagram and radio wiring diagram. Feel free to use any car stereo wiring diagram that is listed on Modified Life but keep in mind that all information here is provided “as is” without any warranty of any kind. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2005 Hyundai Elantra.

If you can’t find your car radio or stereo wire diagram on Modified Life, please feel free to post a car wiring diagram request at the bottom of this page and we’ll do our best to find you the information you need for your mobile installation.

2005 Hyundai Elantra Car Stereo Radio Wiring Diagram

Radio Constant 12V+ Wire: Red
Radio Switched 12V+ Wire: Yellow
Radio Ground Wire: Black
Radio Illumination Wire: Pink
Radio Dimmer Wire: N/A
Radio Power Antenna Trigger Wire: Gray/Orange
Radio Amplifier Turn On Trigger Wire: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Wire (+): White
Left Front Speaker Wire (-): Brown
Right Front Speaker Wire (+): Green
Right Front Speaker Wire (-): Orange
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Wire (+): Yellow
Left Rear Speaker Wire (-): Black
Right Rear Speaker Wire (+): Orange
Right Rear Speaker Wire (-): Blue

Make Your Hyundai Elantra Car Stereo Installation Easy with these Products


  • Reply Stephan Maywalt September 15, 2011 at 10:47 pm

    I have a 400 watt amp ready to go but it seems I cant get through the firewall to the battery. I am not able to hook up the power line from the battery to the box. How do I get through the firewall. There seems to be no holes or access to get my cable through into the car. I have a 2006 Hyundai Elantra. Please respond.

  • Reply ModifiedLife September 19, 2011 at 6:22 pm

    Stephen, most vehicles have a factory hole with a rubber or plastic grommet at the firewall. This is usually the standard place to run a power wire through the firewall. If one of these holes are not available or not large enough, a hole will have to be drilled to accommodate your power wire. Choose something on the engine side of the firewall as reference and try to match it up on the interior side of the firewall. This will make sure you do not drill through anything important. Then drill a hole somewhere near or beside your reference point. Make sure to use a firewall grommet to prevent the power wire from chaffing on the firewall that could potentially cause a short. Hope this helps. Good luck with your 2005 Hyundai Elantra amplifier installation.

  • Reply neil February 23, 2012 at 2:17 am

    I need 96 Hyundai elantra car stereo wiring diagram

  • Reply ModifiedLife February 27, 2012 at 10:01 pm

    Neil, as much as we would like to help you, most of the stereo wire information listed on our website is provided by our visitors. We currently do not have any information on the 1996 Hyundai Elantra radio wiring but hopefully someone from our knowledgeable Modified Life community would be able to post a reply and assist you.

  • Leave a Reply

    5 × 4 =