Comments on: Car Stereo Radio Wiring Diagram – 1998 Honda Accord

By: Emily

Emily — Sat, 20 Feb 2010 17:15:55 +0000

My 98 Honda Accord just had its other non-factory stereo box ripped out of the car, so I just replaced it with a new one. But now the radio gets terrible reception. I made sure the Antenna cable is plugged in and it got great reception with the previous stereo box. Any suggestions? Thanks!

By: ModifiedLife

ModifiedLife — Tue, 24 Nov 2009 02:33:48 +0000

Dan, you would need an adapter to wire an Apple Ipod to your factory stereo. Here is the adapter you need: 1998 Honda Accord Apple iPod Adapter If you've never installed a ipod adapter before, we advise you to take your car to an experienced car audio installer. Hope this helps. Good luck with your Ipod adapter install.

By: Dan

Dan — Mon, 09 Nov 2009 20:23:43 +0000

I noticed my stock radio has Tape/CD button. I don’t have a CD player with it, would it be possible to hook up a wire for my MP3 player with this stereo?

By: aj

aj — Thu, 24 Sep 2009 22:24:28 +0000

i have a 98 honda accord with 2 tweeters in the front right under the windshield. i replaced my stock deck with an aftermarket deck but i cant seem to find the wires that connect to the tweeters on the harness. could you help me figure out what color the wires are or is there something i gotta do?

By: ModifiedLife

ModifiedLife — Fri, 17 Apr 2009 08:05:08 +0000

DJChad, most door panel removals can be done with a Phillips screwdriver and by simply pulling the door panel off by hand. Just look for screws at the edge of the door panel, near the door handle and inside the door pull. Once you remove all the screws, you should be able to pull the door panel off with ease. Hope this helps. Good luck.

By: djchad

djchad — Thu, 09 Apr 2009 18:24:08 +0000

It would be nice if you also had the instructions for door panel removal but I do appreciate that you’re sharing the information you are!

By: ModifiedLife

ModifiedLife — Wed, 14 Jan 2009 06:29:58 +0000

Caleb, after you remove the three screws the the radio frame just pops out. You have to pry the radio frame from the dash. There should be two clips at the top of the frame. Hope this helps. Good luck.

By: Caleb

Caleb — Mon, 12 Jan 2009 22:38:10 +0000

I am installing a ipod ready cable into the back of my double din pioneer receiver. How am I supposed to remove the dash? I have removed the three screws holding the dash to the car. Now i just need to remove the top part of the dash from the clips of what not. What do I do? Thanks

By: Tank

Tank — Wed, 24 Sep 2008 22:01:16 +0000

I know that the 1998 Honda Accord ex is Double Din, but Im not sure how many inches it is. I wanted to know what the dimensions were before I purchased another CD Player. Could you tell me please?

Thank you

By: vbrao

vbrao — Fri, 04 Jan 2008 00:57:40 +0000

Where can i get the 1998 Honda accord radio “14-pin” harness wiring diagram.

I am trying to remove the “Honda” factory installed “cassette” player and replace with CD/Mp3 player.

Thanks