2007 Jeep Grand Cherokee Car Audio Wiring Diagram

Whether your an expert Jeep Grand Cherokee mobile electronics installer, Jeep Grand Cherokee fanatic, or a novice Jeep Grand Cherokee enthusiast with a 2007 Jeep Grand Cherokee, a car stereo wiring diagram can save yourself a lot of time. Automotive wiring in a 2007 Jeep Grand Cherokee vehicles are becoming increasing more difficult to identify due to the installation of more advanced factory oem electronics.

One of the most time consuming tasks with installing an after market car stereo, car radio, satellite radio, xm radio, car speakers, tweeters, car subwoofer, crossovers, audio equalizer, car amplifier, mobile amp, car amplifier, mp3 player, ipod or any car audio electronics is identifying the correct color car audio wires for your 2007 Jeep Grand Cherokee.

The Modified Life staff has taken all its Jeep Grand Cherokee car radio wiring diagrams, Jeep Grand Cherokee car audio wiring diagrams, Jeep Grand Cherokee car stereo wiring diagrams, Jeep Grand Cherokee car radio wiring schematics, Jeep Grand Cherokee car wiring diagrams and cataloged them online for use by our visitors for free. Our automotive wiring diagrams allow you to enjoy your new mobile electronics rather than spend countless hours trying to figure out which wires goes to which 2007 Jeep Grand Cherokee part or component.

Feel free to use any Jeep Grand Cherokee car stereo wiring diagram that is listed on Modified Life but keep in mind that all information here is provided “as is” without any warranty of any kind and most of the car audio wiring diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the Jeep Grand Cherokee wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2007 Jeep Grand Cherokee.

Questions

If you have any questions pertaining to the audio system in the 2007 Jeep Grand Cherokee, please feel free to post it at the bottom of this page and either we’ll do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you’re looking for.

Request a Car Stereo Wiring Diagram

If you can’t find a particular car audio wire diagram on Modified Life, please feel free to post a car radio wiring diagram request at the bottom of this page and we’ll do our best to find you the diagram or schematic you need for your mobile audio installation.

Adding More Information

If you would like to help the Modified Life community by adding any missing information or adding a new car audio wire diagram to our resource, please feel free to post it at the bottom of this page.

2007 Jeep Grand Cherokee Car Audio Wiring Diagram

Car Radio Battery Constant 12v+ Wire: Red/Orange
Car Radio Accessory Switched 12v+ Wire: The radio harness does not provide a switched power source. Run a wire to the Fuse Box for switched power.
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Black/Yellow
Car Stereo Dimmer Wire: Orange
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: If equipped, the factory amplifier is located in behind the trim inside the driver side of the cargo area.
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Dark Green
Left Front Speaker Negative Wire (-): Dark Green/Brown
Right Front Speaker Positive Wire (+): Gray
Right Front Speaker Negative Wire (-): Gray/Brown
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Dark Green/Dark Blue
Left Rear Speaker Negative Wire (-): Dark Green/Violet
Right Rear Speaker Positive Wire (+): Gray/Dark Blue
Right Rear Speaker Negative Wire (-): Gray/Tan

Make Your Jeep Grand Cherokee Car Stereo Installation Easy with these Products

6 Comments

  • Reply matt July 22, 2008 at 9:38 pm

    Where is the factory amp installed on the 07 with the Boston acoustics system?

  • Reply ModifiedLife July 23, 2008 at 2:05 am

    Matt, the factory amplifier is located in behind the interior paneling on the driver side of the cargo (trunk) area. Hope this helps. Good luck.

  • Reply ben January 17, 2010 at 5:25 pm

    has anybody figured out what the car radio accessory switched wire color is?

  • Reply frank May 19, 2010 at 2:33 pm

    could you tell me how to tap into the VSS for installing a aftermarket NAV radio. If you know the colors of the wires that would be helpful. I’m not familiar with the speed sensor. thanks a mill, F.

  • Reply ModifiedLife June 3, 2010 at 3:25 pm

    Frank, use the dark green/brown wire (pin #32) in the black/green plug at the PCM Module for your vehicle speed sensor wire. Hope this helps. Good luck with your 2007 Jeep Cherokee navigation installation.

  • Reply Tom January 1, 2011 at 5:04 pm

    I need to install a 12 v power port for the back seat of my 2007. It fits great to the left of the driver’s seat near the seat belt. Can anyone tell me here to find a positive and negative wire that is suitable to connect the power port. Or please tell me how to connect it to the fuse box. Thanks.

  • Leave a Reply

    14 − 10 =