2007 Jeep Commander Car Stereo Wiring Guide

Whether your an expert Jeep Commander mobile electronics installer, Jeep Commander fanatic, or a novice Jeep Commander enthusiast with a 2007 Jeep Commander, a car stereo wiring diagram can save yourself a lot of time. Automotive wiring in a 2007 Jeep Commander vehicles are becoming increasing more difficult to identify due to the installation of more advanced factory oem electronics.

One of the most time consuming tasks with installing an after market car stereo, car radio, satellite radio, xm radio, car speakers, tweeters, car subwoofer, crossovers, audio equalizer, car amplifier, mobile amp, car amplifier, mp3 player, ipod or any car audio electronics is identifying the correct color car audio wires for your 2007 Jeep Commander.

The Modified Life staff has taken all its Jeep Commander car radio wiring diagrams, Jeep Commander car audio wiring diagrams, Jeep Commander car stereo wiring diagrams, Jeep Commander car radio wiring schematics, Jeep Commander car wiring diagrams and cataloged them online for use by our visitors for free. Our automotive wiring diagrams allow you to enjoy your new mobile electronics rather than spend countless hours trying to figure out which wires goes to which 2007 Jeep Commander part or component.

Feel free to use any Jeep Commander car stereo wiring diagram that is listed on Modified Life but keep in mind that all information here is provided “as is” without any warranty of any kind and most of the car audio wiring diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the Jeep Commander wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2007 Jeep Commander.

Questions

If you have any questions pertaining to the audio system in the 2007 Jeep Commander, please feel free to post it at the bottom of this page and either we’ll do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you’re looking for.

Request a Car Stereo Wiring Diagram

If you can’t find a particular car audio wire diagram on Modified Life, please feel free to post a car radio wiring diagram request at the bottom of this page and we’ll do our best to find you the diagram or schematic you need for your mobile audio installation.

Adding More Information

If you would like to help the Modified Life community by adding any missing information or adding a new car audio wire diagram to our resource, please feel free to contact us at: contact form or post it at the bottom of this page.

2007 Jeep Commander Car Stereo Wiring Guide

Radio Constant 12V+ Wire: Red/Orange
Radio Ignition Switched 12V+ Wire: (CAN data bus)
Radio Ground Wire: Black
Radio Illumination Dimmer Wire: Orange/Brown
Radio Antenna Trigger Wire: N/A
Radio Amplifier Trigger Wire: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Wire (+): Gray/Orange
Left Front Speaker Wire (-): Gray/Yellow
Right Front Speaker Wire (+): Gray/Dark Green
Right Front Speaker Wire (-): Gray/Light Green
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Wire (+): Dark Green/Dark Blue
Left Rear Speaker Wire (-): Dark Green/Purple
Right Rear Speaker Wire (+): Gray/Dark Blue
Right Rear Speaker Wire (-): Gray/Tan

Note: If equipped, the audio amplifier is located in the driver side rear quarter panel.

Make Your Jeep Commander Car Stereo Installation Easy with these Products

10 Comments

  • Reply cico7 July 5, 2008 at 8:19 am

    This is very hepful. I would like to know the details of the factory speakers. 4ohm 8 ohm? How are the dash / front / rear speakers wired?

  • Reply A. SINGH November 3, 2008 at 11:17 am

    i was looking for radio ignition switched 12v+ wire color on jeep commander it tells me (can data bus)

  • Reply ModifiedLife November 4, 2008 at 8:36 pm

    A. Singh, you can find a switched power source at your ignition switch wire harness located in your steering column. Just use the violet/brown wire. Hope this helps. Good luck.

  • Reply Conrad December 30, 2008 at 6:19 pm

    where is the preamp located in the 2006 jeep commander? Help please.

  • Reply nick V June 28, 2010 at 12:17 am

    I can not here my radio on my jeep commander. does it has a built in amp?

  • Reply Rae July 13, 2010 at 11:06 am

    Help! I have a 2007 Jeep Commander & I’m having radio problems… I can turn the power on & off, load/eject cd, radio will tell what song & artist is playing BUT NO SOUND! Is it the radio or is it the speakers?? I took it to the dealer and they want a crazy amount of cash just to look at the radio.

  • Reply ModifiedLife July 14, 2010 at 9:39 pm

    Rae, your 2007 Jeep Commander may have a factory subwoofer amplifier that needs to be turned on by your after market radio. The car stereo amplifier trigger wire has to be wired up to turn on your factory amplifier. Unfortunately, we do not have this information but maybe someone from the Modified Life community can post that information here. Hope this points you in the right direction. Good luck with your 2007 Jeep Commander stereo installation.

  • Reply al velez August 26, 2010 at 10:22 pm

    2007 jeep commander, looking for a power source for a flip down monitor dvd , greatly appreciate any info…………thank you

  • Reply Sonia Torres January 11, 2011 at 11:25 pm

    We have the same problem, can’t hear the radio. We also have leaky windows. My husband was looking for the fuses when he discovered the amp is in the back of the jeep. It was flooded which caused the amp to burn out.

  • Reply Reed January 30, 2013 at 6:01 pm

    Does anyone know where the radio/sound amplifier for an 2007 jeep Commander is located? Has anyone every replaced one, and if so how easy, or difficult was it?

  • Leave a Reply

    twenty − sixteen =