MODIFIEDLIFE

2006 Mercury Milan Car Alarm Wiring Guide


Whether your an expert Mercury Milan car alarm installer, Mercury Milan performance fan or a novice Mercury Milan enthusiast with a 2006 Mercury Milan, a Mercury Milan car alarm wiring diagram can save yourself a lot of time. One of the most time consuming tasks with installing an after market car alarm, car security, car remote start, automatic remote starter, shock sensor, tilt sensor, car alarm sensor or any auto alarm is identifying the correct color car security wires for a 2006 Mercury Milan headlight bulb size you need for your low beam or high beam and save time. Also, find your other car light bulb sizes including your fog light, reverse light, turn signal, brake light and more. It’s that easy!

The Modified Life staff has taken all its Mercury Milan car alarm wiring diagrams, Mercury Milan car security wiring diagrams, Mercury Milan car alarm wire diagrams, Mercury Milan car security wiring schematics, Mercury Milan car security diagrams, Mercury Milan remote starter wiring diagrams and cataloged them online for our visitors to use for free. Our automotive wiring diagrams allow you to enjoy your new auto security electronics rather than spend countless hours trying to figure out which wires goes where.

Feel free to use any Mercury Milan auto alarm wiring diagram that is listed on Modified Life but keep in mind that all information here is provided “as is” without any warranty of any kind and most of the auto security wiring diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2006 Mercury Milan.

Questions

If you have any questions pertaining to the car wiring in a 2006 Mercury Milan, please feel free to post it at the bottom of this page and either we’ll do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you are looking for.

Request a Car Alarm Wiring Diagram

If you can’t find your car alarm wiring, car security wire diagram or auto alarm wire diagram on Modified Life, please feel free to post a car alarm wiring diagram request on this page and we’ll do our best to find you the diagram, schematic or information you need for your mobile security installation.

Adding More Information

If you would like to help the Modified Life community by adding a car security wire schematic, car alarm wire diagram, car remote starter wire diagram, auto remote starter wire diagram or auto security wire diagram to our resource, please feel free to post any additional car wiring information about the 2006 Mercury Milan on this page.

2006 Mercury Milan Car Alarm Wiring Guide

Battery Constant 12v+ Positive Wire (+): Brown/Red (+)
Battery Constant 12v+ Positive Wire Location: At Ignition Switch Harness

Starter Positive Wire (+): Blue/White (+)
Starter Positive Wire Location: At Ignition Switch Harness

Ignition Positive Wire (+): White/Orange (+)
Ignition Positive Wire Location: At Ignition Switch Harness

Accessory Positive Wire (+): Purple/Green (+)
Accessory Positive Wire Location: At Ignition Switch Harness

Parking Light Negative Wire (-): Gray (-)
Parking Light Negative Wire Location: At Headlight Switch Or SJB (Connector D, Pin 5). The SJB (smart junction box) is part of the fuse/relay box under the drivers side of the dash.

Parking Light Positive Wire (+): Gray/Yellow (+)
Parking Light Positive Wire Location: In Drivers Kick Panel Or SJB (Connector E, Pin 30). The SJB (smart junction box) is part of the fuse/relay box under the drivers side of the dash.

Power Door Lock Negative Wire (-): Gray/Yellow (Negative (-))
Power Door Lock Negative Wire Location: In Driver Kick Panel Or SJB (Connector C, Pin 4). The SJB (smart junction box) is part of the fuse/relay box under the drivers side of the dash. On vehicles with memory seats, the power lock and unlock wires are in the passenger kick panel or SJB (smart junction box) and you will need to test these wires while using the lock/unlock switch on the passenger door only.

Power Door Unlock Negative Wire (-): Purple/Gray (Negative (-))
Power Door Unlock Negative Wire Location: In Drivers Kick Panel Or SJB (Connector C, Pin 10). The SJB (smart junction box) is part of the fuse/relay box under the drivers side of the dash. On vehicles with memory seats, the power lock and unlock wires are in the passenger kick panel or SJB (smart junction box) and you will need to test these wires while using the lock/unlock switch on the passenger door only.

Door Trigger Positive Wire (+): Use Dome Light Supervision Wire
Door Trigger Positive Wire Location: N/A

Dome Light Supervision Wire: Blue (+)
Dome Light Supervision Wire Location: In Drivers Kick Panel Or SJB (Connector E, Pin 16). The SJB (smart junction box) is part of the fuse/relay box under the drivers side of the dash. The dome light supervision wire blue (+) can also be located in the passenger side “a” pillar.

Trunk Release Negative Wire (-): Brown (-)
Trunk Release Negative Wire Location: At Trunk Release Switch Or SJB (Connector D, Pin 27). The SJB (smart junction box) is part of the fuse/relay box under the drivers side of the dash.

Horn Negative Negative Wire (-): Blue/White (-)
Horn Negative Negative Wire Location: At Horn Switch Or SJB (Connector B, Pin 6). The SJB (smart junction box) is part of the fuse/relay box under the drivers side of the dash.

Tachometer Wire Negative Wire (-): Not Gray Or White/Blue
Tachometer Wire Negative Wire Location: At Any Fuel-Injector Or Ignition Coil

Brake Light Positive Wire (+): Purple/White (+)
Brake Light Positive Wire Location: At Switch Above Brake Pedal Or SJB (Connector A, Pin 19). The SJB (smart junction box) is part of the fuse/relay box under the drivers side of the dash.

Factory Alarm Disarm Wire (-): Purple/Brown (-)
Factory Alarm Disarm Wire Location: In Drivers Kick Panel Or SJB (Connector C, Pin 5). The SJB (smart junction box) is part of the fuse/relay box under the drivers side of the dash. Test this wire will turning the key in the drivers door key cylinder.

Factory Anti-Theft System: Ford’s Securilock anti-theft transponder system.

Leave a Comment

Your email address will not be published. Required fields are marked *