2006 Dodge Stratus Car Radio Stereo Wiring Diagram

Whether your an expert installer or a novice enthusiast with a 2006 Dodge Stratus, an automotive wiring diagram can save yourself time and headaches. One of the most time consuming tasks with installing a car stereo, car radio, car speakers, car amplifier, car navigation or any mobile electronics is identifying the correct wires for a 2006 Dodge Stratus.

The Modified Life staff has put their heads together to create an invaluable resource containing free car stereo wiring diagram, free car wiring diagram and free radio wiring diagram. Feel free to use any car stereo wiring diagram or factory radio wire colors that are listed on Modified Life but keep in mind that all information here is provided “as is” without any warranty of any kind. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2006 Dodge Stratus.

If you can’t find your car radio wiring diagram, factory radio wire colors or stereo wire diagram on Modified Life, please feel free to post a car wiring diagram request (Radio Wiring Diagram Request Page) and we’ll do our best to find you the information you need for your mobile installation.

2006 Dodge Stratus Car Stereo Radio Wiring Diagram

Car Radio Constant 12V+ Wire: Pink
Car Radio Ignition Switched 12V+ Wire: Red/White
Car Radio Ground Wire: Black
Car Stereo Illumination Wire: Orange/Brown
Car Stereo Dimmer Wire: Same as Power Antenna Wire.
Car Stereo Antenna Trigger Wire: Dark Green/Red
Car Stereo Amplifier Trigger Wire: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Wire (+): Dark Green
Left Front Speaker Wire (-): Brown/Red
Right Front Speaker Wire (+): Purple
Right Front Speaker Wire (-): Dark Blue/Red
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Wire (+): Brown/Yellow
Left Rear Speaker Wire (-): Brown/Light Blue
Right Rear Speaker Wire (+): Dark Blue/White
Right Rear Speaker Wire (-): Dark Blue/Orange

Notes: If equipped, the amplifier is under the passenger seat.

Make Your Dodge Stratus Stereo Installation Easy with these Products

6 Comments

  • Reply scott tran September 22, 2010 at 7:10 pm

    this site was very helpful to me as this was my first time wiring a car stereo and i didnt know what was what till i checked this place it is very helpful!!!!!!

  • Reply ModifiedLife September 28, 2010 at 5:05 pm

    Scott, we are happy we could help you with your 2006 Dodge Stratus stereo wiring diagram needs.

  • Reply timg October 1, 2010 at 7:21 pm

    what wire would i hook my remote line from my amp to??

  • Reply ModifiedLife October 5, 2010 at 7:58 pm

    Timg, technically you could connect your 2006 Dodge Stratus amplifier turn on wire to the radio switched 12v+ wire (red/white). That way your amplifier is on whenever your 2006 Dodge Stratus is on and off whenever your 2006 Dodge Stratus is off. Just make sure to run an in-line fuse holder with a 1-amp fuse on the amplifier turn on wire. Hope this helps. Good luck with your 2006 Dodge Stratus amplifier install.

  • Reply jose March 31, 2011 at 3:13 pm

    where do i run my power cable thru? is there a specific spot in the fire wall? please held thanx in advanced

  • Reply ModifiedLife April 4, 2011 at 4:50 pm

    Jose, most vehicles have a factory hole with a rubber or plastic grommet at the firewall. This is usually the standard place to run a power wire through the firewall. If one of these holes are not available or not large enough, a hole will have to be drilled to accommodate your power wire. Choose something on the engine side of the firewall as reference and try to match it up on the interior side of the firewall. This will make sure you do not drill through anything important. Then drill a hole somewhere near or beside your reference point. Make sure to use a firewall grommet to prevent the power wire from chaffing on the firewall that could potentially cause a short. Hope this helps. Good luck with your 2006 Dodge Stratus amplifier installation.

  • Leave a Reply

    4 × 3 =