MODIFIEDLIFE

2006 Dodge Ram 1500 Remote Starter Wiring Instructions


Whether you’re a novice Dodge Ram 1500 enthusiast, an expert Dodge Ram 1500 mobile electronics installer or a Dodge Ram 1500 fan with a 2006 Dodge Ram 1500, a remote start wiring diagram can save yourself a lot of time. The automotive wiring harness in a 2006 Dodge Ram 1500 is becoming increasing more complicated and more difficult to identify due to the installation of more advanced automotive electrical wiring. One of the most difficult jobs is figuring out where wiring for remote start, remote starter, remote vehicle starter, remote car starter, remote auto starter, remote automotive starter, remote auto starter or remote start module should be connected to on your 2006 Dodge Ram 1500.

The Modified Life staff has taken every 2006 Dodge Ram 1500 remote start wiring diagram, 2006 Dodge Ram 1500 remote start wireing diagram, 2006 Dodge Ram 1500 remote starter wiring diagram, 2006 Dodge Ram 1500 remote starter diagram, 2006 Dodge Ram 1500 wiring for remote start, 2006 Dodge Ram 1500 remote start wire diagram, 2006 Dodge Ram 1500 remote starter wiring diagram, 2006 Dodge Ram 1500 remote start install diagram and cataloged them online for use by our visitors for free. Our remote start wiring schematics allow you to enjoy remote car starting for an air conditioned cabin in the summer and remote vehicle starting for a warm interior in the winter. Stop spending countless hours trying to figure out which remote start wires go to which 2006 Dodge Ram 1500 electrical module or automotive harness.

Feel free to use any Dodge Ram 1500 remote start wiring diagram that is listed on Modified Life but keep in mind that all the information here is provided “as is” without any warranty of any kind and most of the remote start wiring schematics listed on our enthusiast website are submitted by the Modified Life community. Use of the Dodge Ram 1500 wiring diagram is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2006 Dodge Ram 1500.

Questions

If you have any questions pertaining to the remote starter wiring in the 2006 Dodge Ram 1500, please feel free to post it at the bottom of this page and either we’ll do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you’re looking for.

Request a Remote Start Wiring Diagram

If you can’t find a particular remote starter wiring guide on Modified Life, please feel free to post a remote start wire diagram request at the bottom of this page and we’ll do our best to find you the diagram or schematic you need for your remote start installation.

Adding More Information

If you would like to help the Modified Life community by adding any missing 2006 Dodge Ram 1500 information or adding a new remote car starter wiring schematic to our resource, please feel free and post it at the bottom of this page.

2006 Dodge Ram 1500 Remote Starter Wiring Instructions

Vehicle Battery Positive Wire (+): Light Blue/Red (Low current. For high current application go directly to the battery.)
Vehicle Battery Positive Wire Location: Ignition Switch Harness

Vehicle Ignition Wire (+): Pink/White
Vehicle Ignition Wire Location: Ignition Switch Harness

Vehicle Second Ignition Wire (+): Pink/Green (There may not be an second ignition wire.)
Vehicle Second Ignition Wire Location: Ignition Switch Harness

Vehicle Accessory Wire (+): Violet/Brown (Use 610 ohm resistor for accessory, same wire as starter2.)
Vehicle Accessory Wire Location: Ignition Switch Harness

Vehicle Second Accessory Wire (+): Pink/Yellow (This wire will turn on the abs light if not powered up for remote start.)
Vehicle Second Accessory Wire Location: Ignition Switch Harness

Automobile Engine Starter Wire (+): Dark Green/Yellow (Not for remote start, use starter2.)
Automobile Engine Starter Wire Location: Ignition Switch Harness

Automobile Second Engine Starter Wire (-): Violet/Brown (Use 180 ohm resistor for starter2, same wire as accessory.)
Automobile Second Engine Starter Wire Location: Ignition Switch Harness

Factory Anti-Theft System: Daimler Sentry Key Vehicle Immobilizer
Factory Anti-Theft System Type: Key Sends a RF Signal to the BCM Module Through an Antenna Located Around the Ignition Cylinder

Crankshaft Sensor Wire: N/A
Crankshaft Sensor Wire Location: N/A

Camshaft Sensor Wire: N/A
Camshaft Sensor Wire Location: N/A

Car Key Sense Wire (-): Violet/Brown (Use an 8.5k ohm resistor for key sense, same wire as starter 2 and accessory.)
Car Key Sense Wire Location: Ignition Switch Harness

Car Neutral Safety Wire (+): N/A
Car Neutral Safety Wire Location: N/A

Car Tachometer Wire (-): Tan/Red
Car Tachometer Wire Location: At Ignition Coil (On diesel models, the tachometer wire is at the ECM module on the lower driver side of the engine, pin #24 in front 60-pin plug or at the camshaft position sensor located at the left of the ECM at the 3 pin plug. On SRT-10 models, the tachometer wire is on the black plug – pin 18.)

Car Speed Sense Wire: Green/Yellow
Car Speed Sense Wire Location: Pin #13 in Black Plug at PCM Module (For SRT-10 models, pin 27 in white plug or dark blue/orange wire. In diesel models, pin 11 at the PCM module.)

Car Parking Lights Wire (-): White/Green (Parking lights are negative trigger thru a 1130 or 250 ohm resistor. Must use a relay.)
Car Parking Lights Wire Location: At Vehicle Light Switch

Car Brake Lights Wire (+): White/Tan
Car Brake Lights Wire Location: At Brake Switch Above the Pedal

Car Reverse Lights Wire (+): White/Light Green
Car Reverse Lights Wire Location: In Harness at Reverse Light

Car Horn Wire (-): Green/Violet
Car Horn Wire Location: In Harness at Steering Column

Car Rear Defrost Wire: N/A
Car Rear Defrost Wire Location: N/A

The 2006 Dodge Ram 1500 remote start wire color and location information above is updated as it is submitted by the Modified Life community.

Leave a Comment

Your email address will not be published. Required fields are marked *