2006 Dodge Ram 1500 Car Alarm Wiring Diagram

Whether your an expert Dodge Ram 1500 car alarm installer, Dodge Ram 1500 performance fan or a novice Dodge Ram 1500 enthusiast with a 2006 Dodge Ram 1500, a 2006 Dodge Ram 1500 car alarm wiring diagram can save yourself a lot of time. One of the most time consuming tasks with installing an after market car alarm, car security, car remote start, automatic remote starter, shock sensor, tilt sensor, car alarm sensor or any auto alarm is identifying the correct color car security wires for a 2006 Dodge Ram 1500 headlight bulb size you need for your low beam or high beam and save time. Also, find your other car light bulb sizes including your fog light, reverse light, turn signal, brake light and more. It’s that easy!

The Modified Life staff has taken all its Dodge Ram 1500 car alarm wiring diagrams, Dodge Ram 1500 car security wiring diagrams, Dodge Ram 1500 car alarm wire diagrams, Dodge Ram 1500 car security wiring schematics, Dodge Ram 1500 car security diagrams, Dodge Ram 1500 remote starter wiring diagrams and cataloged them online for our visitors to use for free. Our automotive wiring diagrams allow you to enjoy your new auto security electronics rather than spend countless hours trying to figure out which wires goes where.

Feel free to use any Dodge Ram 1500 auto alarm wiring diagram that is listed on Modified Life but keep in mind that all information here is provided as-is without any warranty of any kind and most of the auto security wiring diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2006 Dodge Ram 1500.

Questions

If you have any questions pertaining to the car wiring in a 2006 Dodge Ram 1500, please feel free to post it at the bottom of this page and either we will do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you are looking for.

Request a Car Alarm Wiring Diagram

If you can not find your car alarm wiring, car security wire diagram or auto alarm wire diagram on Modified Life, please feel free to post a car alarm wiring diagram request on this page and we will do our best to find you the diagram, schematic or information you need for your mobile security installation.

Adding More Information

If you would like to help the Modified Life community by adding a car security wire schematic, car alarm wire diagram, car remote starter wire diagram, auto remote starter wire diagram or auto security wire diagram to our resource, please feel free to post any additional car wiring information about the 2006 Dodge Ram 1500 on this page.

2006 Dodge Ram 1500 Car Alarm Wiring Instructions

Battery Constant 12v+ Positive Wire (+): Connect To Battery Only
Battery Constant 12v+ Positive Wire Location: Under The Hood

Starter Positive Wire (+): Dark Green/Yellow
Starter Positive Wire Location: At Ignition Harness Or Starter Button (SRT-10)

Second Starter Positive Wire (+): Purple/Brown (Requires A 180 Ohm Resistor And Relay). The starter #2 wire and accessory wire are combined into 1-wire system, the starter #2 will require a (-) negative through a 180 ohm resistor and an extra relay. The accessory will require (-) negative through a 610 ohm resistor and an extra relay.
Second Starter Positive Wire Location: At Ignition Harness

Ignition Positive Wire (+): Pink/White
Ignition Positive Wire Location: At Ignition Harness

Second Ignition Positive Wire (+): N/A
Second Ignition Positive Wire Location: N/A

Third Ignition Positive Wire (+): N/A
Third Ignition Positive Wire Location: N/A

Accessory Positive Wire (+): Same As Second Starter Wire, Uses 610 Ohm Resistor And Relay. The starter #2 wire and accessory wire are combined into 1-wire system, the starter #2 will require a (-) negative through a 180 ohm resistor and an extra relay. The accessory will require (-) negative through a 610 ohm resistor and an extra relay.
Accessory Positive Wire Location: At Ignition Harness

Second Accessory Positive Wire (+): N/A
Second Accessory Positive Wire Location: N/A

Key Sense Wire: N/A
Key Sense Wire Location: N/A

Parking Light Negative Wire (-): White/Light Green (Requires A 1130 Ohm Resistor And Relay). The negative parking lights require a (-) negative through a 1130 ohm resistor or a 2200 ohm resistor and an extra relay.
Parking Light Negative Wire Location: At Headlight Switch Or Instrument Cluster, Small Gray Plug, Pin 5

Parking Light Positive Wire (+): White/Yellow (+) Left Side And White/Gray (+) Right Side (Use Both). Requires (2) Extra Relays.
Parking Light Positive Wire Location: At Harness, Top Of Drivers Fender

Power Door Lock Negative Wire (-): Purple/Dark Green, 1-Wire System, Requires Extra Resistors. This vehicle is a 1-wire door locking system that requires a (-) negative through 820 ohm resistor to lock and requires (-) negative through a 330 ohm resistor to unlock.
Power Door Lock Negative Wire Location: In Drivers Kick Panel Or Instrument Cluster, Small Gray Plug, Pin 3

Power Door Unlock Negative Wire (-): Same Wire
Power Door Unlock Negative Wire Location: N/A

Door Trigger Negative Wire (-): The drivers door is a purple (-) at pin 1, the passenger door is a purple/white (-) at pin 4, the drivers rear door is a purple/orange (-) or purple/gray (-) at pin 2, the passenger rear door is a purple/yellow (-) or tan/yellow (-) at pin 3. When connecting to an alarm system use all 4 wires and diode isolate.
Door Trigger Negative Wire Location: In Each Kick Panel Or Instrument Cluster, Large Gray Plug

Dome Light Supervision Wire (+): Yellow/Light Blue (Requires Relay)
Dome Light Supervision Wire Location: At A Pillar Or Instrument Cluster, White Plug, Pin 21

Trunk Release Negative Wire (-): N/A
Trunk Release Negative Wire Location: N/A

Sliding Power Door Wire: N/A
Sliding Power Door Wire Location: N/A

Horn Negative Wire (-): Dark Green/Purple
Horn Negative Wire Location: At Horn Switch Or Instrument Cluster, Large Gray Plug, Pin 14

Tachometer Wire Negative Wire (-): Dark Blue/Gray (The PCM (powertrain control module) is on the passenger side firewall. The black/orange plug is the second plug down from the top. On the SRT-10 the tachometer is in the black plug, pin 18. On diesel’s the tachometer wire is at the ECM, on the lower drivers side of the engine, front 60-pin plug, pin 24 or at the camshaft position sensor just left of the ECM in a 3-pin plug.)
Tachometer Wire Negative Wire Location: At PCM, Black/Orange Plug, Pin 34

Wait To Start Wire: N/A
Wait To Start Location: N/A

Brake Light Positive Wire (+): White/Tan
Brake Light Positive Wire Location: At Switch Above Brake Pedal

Factory Alarm Disarm Wire (-): Factory Remote Only
Factory Alarm Disarm Wire Location: N/A

Factory Anti-Theft System: Chrysler’s Sentry Key, A Transponder System
Factory Anti-Theft System Location: At Ignition Switch Tumbler

The 2006 Dodge Ram 1500 alarm wire color information above is updated as it is submitted by the Modified Life community.