MODIFIEDLIFE

2006 Chrysler Town Country Car Alarm Wire Colors


Whether your an expert Chrysler Town Country car alarm installer, Chrysler Town Country performance fan or a novice Chrysler Town Country enthusiast with a 2006 Chrysler Town Country, a Chrysler Town Country car alarm wiring diagram can save yourself a lot of time. One of the most time consuming tasks with installing an after market car alarm, car security, car remote start, automatic remote starter, shock sensor, tilt sensor, car alarm sensor or any auto alarm is identifying the correct color car security wires for a 2006 Chrysler Town Country headlight bulb size you need for your low beam or high beam and save time. Also, find your other car light bulb sizes including your fog light, reverse light, turn signal, brake light and more. It’s that easy!

The Modified Life staff has taken all its Chrysler Town Country car alarm wiring diagrams, Chrysler Town Country car security wiring diagrams, Chrysler Town Country car alarm wire diagrams, Chrysler Town Country car security wiring schematics, Chrysler Town Country car security diagrams, Chrysler Town Country remote starter wiring diagrams and cataloged them online for our visitors to use for free. Our automotive wiring diagrams allow you to enjoy your new auto security electronics rather than spend countless hours trying to figure out which wires goes where.

Feel free to use any Chrysler Town Country auto alarm wiring diagram that is listed on Modified Life but keep in mind that all information here is provided as-is without any warranty of any kind and most of the auto security wiring diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2006 Chrysler Town Country.

Questions

If you have any questions pertaining to the car wiring in a 2006 Chrysler Town Country, please feel free to post it at the bottom of this page and either we will do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you are looking for.

Request a Car Alarm Wiring Diagram

If you can not find your car alarm wiring, car security wire diagram or auto alarm wire diagram on Modified Life, please feel free to post a car alarm wiring diagram request on this page and we will do our best to find you the diagram, schematic or information you need for your mobile security installation.

Adding More Information

If you would like to help the Modified Life community by adding a car security wire schematic, car alarm wire diagram, car remote starter wire diagram, auto remote starter wire diagram or auto security wire diagram to our resource, please feel free to post any additional car wiring information about the 2006 Chrysler Town Country on this page.

2006 Chrysler Town Country Automotive Alarm Wire Colors

Battery Constant 12v+ Positive Wire (+): Light Blue/Red
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness

Starter Positive Wire (+): Yellow
Starter Positive Wire Location: Ignition Switch Harness

Second Starter Positive Wire (+): Violet/Brown (Must use relay to enhance ground during crank only with a 180 Ohm Resistor. If you do not have 4 pin auxiliary harness, attach the light blue (ignition 3) to 85, tap off the starter wire to 86, ground the 180 ohm resistor and attach to 87 and cut the violet/brown.)
Second Starter Positive Wire Location: Ignition Switch Harness

Ignition Positive Wire (+): Pink/White
Ignition Positive Wire Location: Ignition Switch Harness

Second Ignition Positive Wire (+): N/A
Second Ignition Positive Wire Location: N/A

Third Ignition Positive Wire (+): N/A
Third Ignition Positive Wire Location: N/A

Accessory Positive Wire (+): N/A
Accessory Positive Wire Location: N/A

Second Accessory Positive Wire (+): N/A
Second Accessory Positive Wire Location: N/A

Key Sense Wire: Light Blue
Key Sense Wire Location: Ignition Switch Harness

Parking Light Negative Wire (-): White/Brown (Use a 1.5K Ohm Resistor)
Parking Light Negative Wire Location: At Headlight Switch

Parking Light Positive Wire (+): N/A
Parking Light Positive Wire Location: N/A

Power Door Lock Negative Wire (-): Violet/Dark Green
Power Door Lock Negative Wire Location: Pin #21 at BCM Module (Use a 5.3K Ohm Resistor)

Power Door Unlock Negative Wire (-): Violet/Dark Green
Power Door Unlock Negative Wire Location: Pin #21 at BCM Module (Use a 2K Ohm Resistor)

Door Trigger Negative Wire (-): Yellow/Orange
Door Trigger Negative Wire Location: At BCM Module

Dome Light Supervision Wire (-): N/A
Dome Light Supervision Wire Location: N/A

Trunk Release Negative Wire (-): N/A
Trunk Release Negative Wire Location: N/A

Sliding Power Door Wire: N/A
Sliding Power Door Wire Location: N/A

Horn Negative Wire (-): Dark Green/Violet
Horn Negative Wire Location: At Steering Column Hanress

Tachometer Wire Negative Wire (-): Dark Blue/Green
Tachometer Wire Negative Wire Location: Pin #9 in 34-Pin at BCM Module

Wait To Start Wire: N/A
Wait To Start Location: N/A

Brake Light Positive Wire (+): White/Tan
Brake Light Positive Wire Location: At Switch Above Brake Pedal

Factory Alarm Disarm Wire (-): N/A
Factory Alarm Disarm Wire Location: N/A

Factory Anti-Theft System: Daimler Sentry Key Vehicle Immobilizer
Factory Anti-Theft System Location: Key Sends RF Signal to the BCM Module

The 2006 Chrysler Town Country alarm wire color and location information above is updated as it is submitted by the Modified Life community.

Leave a Comment

Your email address will not be published. Required fields are marked *