2003 Toyota 4Runner Car Light Bulb Size Schematic

When you need to replace the headlight, turning signal or parking light bulb on your 2003 Toyota 4Runner, finding out what the replacement size you need can be a time consuming task. Whether you want to replace your headlamp bulb with a HID (High Intensity Discharge) Headlight Kit, Xenon Headlamp Kit or replace your interior lighting bulbs with LED (Light Emitting Diode) bulbs, we’re here to help you with your 2003 Toyota 4Runner.

The Modified Life staff has taken all its Toyota 4Runner headlight bulb replacement guide, Toyota 4Runner light bulb size guides, Toyota 4Runner light bulb replacement guides and cataloged them online for use by our visitors for free. Our Toyota 4Runner light bulb guides allow you to easily replace light bulbs, replace headlight bulb, change a broken lightbulb, install a hid headlight conversion or install led light bulbs instead of spending countless hours trying to figure out which light bulb sizes in your 2003 Toyota 4Runner.

Feel free to use any replacement light bulb sizes that are listed on Modified Life but keep in mind that all information here is provided as is without any warranty of any kind. Use of the replacement bulb size information is at your own risk. Always verify all light bulb sizes, bulb voltage usage and bulb wattage before applying any information found here to your 2003 Toyota 4Runner.

Request a Light Bulb Size Guide

If you can’t find a particular replacement light bulb size guide on Modified Life, please feel free to post a light bulb size guide request at the bottom of this page and we’ll do our best to find you the light bulb size or light bulb replacement information you need for your vehicle.

Adding More Information

If you would like to help the Modified Life community by adding any missing information or adding a new light bulb size information to our resource, please feel free to post it at the bottom of this page.

2003 Toyota 4Runner Car Light Bulb Size Schematic

Low Beam Headlight Bulb Size: 9006 or 9006 HID Upgrade Kit
High Beam Headlamp Light Bulb Size: 9005 or 9005 HID Upgrade Kit
Parking Light Bulb Size: 168
Front Turn Signal Light Bulb Size: 992 (7440A)
Rear Turn Signal Light Bulb Size: 992 (7440A)
Tail Light Bulb Size: 7443
Stop Light Bulb Size: 7443
High Mount Stop Light Bulb Size: 921
Fog/Driving Light Bulb Size: 9006
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 921
Front Side Marker Light Bulb Size: 168
Rear Sidemarker Light Bulb Size: 7443
Glove Box Light Bulb Size: 37
Map Light Bulb Size: 168
Dome Light Bulb Size: DE3175
Step/Courtesy Light Bulb Size: 194 or DE3021
Trunk/Cargo Area Light Bulb Size: DE3175

Upgrade Your Car Light Bulbs with Newer Brighter Bulbs

13 Comments

  • Reply Bonnie August 3, 2009 at 7:18 am

    My 2003 4Runner needs the driver’s side brake light. Can you tell me which light I need and how to do this instead of bringing it to a shop.

    Thank you very much!
    Bonnie

  • Reply ModifiedLife August 11, 2009 at 12:24 am

    Bonnie, if you open your tailgate (trunk) and look at your taillight, you should be able to see a couple of screws that hold your tail light to your 2003 Toyota 4Runner. Remove those screws and your taillight should slide out. After you remove the driver side tail light, you should be able to swap out the dead light bulb. Hope this helps. Good luck with changing the light bulb.

  • Reply Bob Kay August 31, 2009 at 3:02 pm

    I need to change the Right turn signal, only the light bulb. How do I take the light bulb out. I hope I don’t have to take the bumper cover off. Thank you so much for your help. Bob

  • Reply Bob Kay August 31, 2009 at 3:07 pm

    I’m sorry I forgot to mention that my car is 2003 toyota 4 runner . sorry again Bob

  • Reply ModifiedLife September 9, 2009 at 4:20 pm

    Bob, are you talking about the front or rear turn signal light?

  • Reply Jeff Fox November 16, 2009 at 5:03 pm

    I need to change the stop light bulb in my 2003 Toyota 4Runner. I don’t know how to get to the bulb. It appears that the red plastic cover pops off but I don’t want to put too much pressure in the wrong place and break it. Can you advise me on this? Thanks, Jeff.

  • Reply Jack November 28, 2009 at 5:41 pm

    I have a 2008 toyota 4runner, how do i change the high mount break light?

  • Reply Ron December 13, 2010 at 9:58 am

    on my toyota 4runner 03 where it shows your remaining miles and clock, the area where the clock is at the right side light is out. How do I change that bulb?

  • Reply Gary January 6, 2011 at 11:02 am

    How do I change the Front Left Turn-Signal Light in a 2003 Toyota Sequoia? Please advise.

  • Reply Ron January 11, 2011 at 12:10 pm

    does anyone know how to change the light bulb for the display on the clock/mileage area on a 2003 toyota 4runner?

  • Reply Gary Bordelon March 14, 2011 at 10:13 am

    I sent you a request about how do I change the Front Left Turn-Signal Light in a 2003 Toyota Sequoia in January. Did you figure that out yet? Did not receive any answer.

  • Reply ModifiedLife March 15, 2011 at 7:20 pm

    Gary, as much as we would like to help you, most of the information listed on our website is provided by our visitors. We only have the light bulb sizes on your 2003 Toyota 4Runner. We don’t have the specific information on how to change light bulbs on your 2003 Toyota 4Runner but hopefully someone from our Modified Life community would be able to chime in.

  • Reply Kylie March 1, 2012 at 12:53 am

    Once you pull off the heating control/clock console you will see some small gray colored battery looking knobs on the back of the clock. They should have a lengthwise score in them. Use a flat head screwdriver and turn them counter clockwise and then they will just fall right out once you turn the unit over. Then to put the new ones in use the same flat head screwdriver and turn them clockwise using moderate pressure. I know this works because I just did it! The dealer told me that there was a “coil burned out in my console that could not be replaced.” And that I would have to pay $1200 for a whole new console. I then went to the parts department and asked for the bulbs. Just because I’m a girl does not mean I’m stupid!! Hope this helps you.

  • Leave a Reply

    seven + 19 =