MODIFIEDLIFE

2002 Chrysler Prowler Auto Alarm Wiring Diagram


Whether your an expert Chrysler Prowler car alarm installer, Chrysler Prowler performance fan or a novice Chrysler Prowler enthusiast with a 2002 Chrysler Prowler, a Chrysler Prowler car alarm wiring diagram can save yourself a lot of time. One of the most time consuming tasks with installing an after market car alarm, car security, car remote start, automatic remote starter, shock sensor, tilt sensor, car alarm sensor or any auto alarm is identifying the correct color car security wires for a 2002 Chrysler Prowler headlight bulb size you need for your low beam or high beam and save time. Also, find your other car light bulb sizes including your fog light, reverse light, turn signal, brake light and more. It’s that easy!

The Modified Life staff has taken all its Chrysler Prowler car alarm wiring diagrams, Chrysler Prowler car security wiring diagrams, Chrysler Prowler car alarm wire diagrams, Chrysler Prowler car security wiring schematics, Chrysler Prowler car security diagrams, Chrysler Prowler remote starter wiring diagrams and cataloged them online for our visitors to use for free. Our automotive wiring diagrams allow you to enjoy your new auto security electronics rather than spend countless hours trying to figure out which wires goes where.

Feel free to use any Chrysler Prowler auto alarm wiring diagram that is listed on Modified Life but keep in mind that all information here is provided as-is without any warranty of any kind and most of the auto security wiring diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 2002 Chrysler Prowler.

Questions

If you have any questions pertaining to the car wiring in a 2002 Chrysler Prowler, please feel free to post it at the bottom of this page and either we will do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you are looking for.

Request a Car Alarm Wiring Diagram

If you can not find your car alarm wiring, car security wire diagram or auto alarm wire diagram on Modified Life, please feel free to post a car alarm wiring diagram request on this page and we will do our best to find you the diagram, schematic or information you need for your mobile security installation.

Adding More Information

If you would like to help the Modified Life community by adding a car security wire schematic, car alarm wire diagram, car remote starter wire diagram, auto remote starter wire diagram or auto security wire diagram to our resource, please feel free to post any additional car wiring information about the 2002 Chrysler Prowler on this page.

2002 Chrysler Prowler Auto Alarm Wiring Instructions

Battery Constant 12v+ Positive Wire (+): Pink/Black And Red/Yellow
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness

Starter Positive Wire (+): Yellow
Starter Positive Wire Location: Ignition Switch Harness

Second Starter Positive Wire (+): N/A
Second Starter Positive Wire Location: N/A

Ignition Positive Wire (+): Blue
Ignition Positive Wire Location: Ignition Switch Harness

Second Ignition Positive Wire (+): Red/White (Small Gauge Wire)
Second Ignition Positive Wire Location: Ignition Switch Harness

Third Ignition Positive Wire (+): N/A
Third Ignition Positive Wire Location: N/A

Accessory Positive Wire (+): Black/Orange
Accessory Positive Wire Location: Ignition Switch Harness

Second Accessory Positive Wire (+): N/A
Second Accessory Positive Wire Location: Ignition Switch Harness

Key Sense Wire: Light Blue (-)
Key Sense Wire Location: Ignition Switch Harness

Parking Light Negative Wire (-): Light Green/Red
Parking Light Negative Wire Location: At Headlight Switch

Parking Light Positive Wire (+): Black/Yellow
Parking Light Positive Wire Location: At Blue, 22-Pin Plug Above Brake

Power Door Lock Positive Wire (+): Orange/Violet
Power Door Lock Positive Wire Location: At BCM, Connector 2, Pin 41. The BCM (body control module) is located in the drivers kick panel. Connector 1 is white, and on top with plug towards the front of the vehicle, connector 2 is white, and on top with plug towards the rear of vehicle. Connector 3 is black and at the bottom.

Power Door Unlock Positive Wire (+): Pink/Violet
Power Door Unlock Positive Wire Location: At BCM, Connector 2, Pin 75. The BCM (body control module) is located in the drivers kick panel. Connector 1 is white, and on top with plug towards the front of the vehicle, connector 2 is white, and on top with plug towards the rear of vehicle. Connector 3 is black and at the bottom.

Door Trigger Negative Wire (-): Tan And Tan/Red (Use Both). When connecting to an alarm system use both wires and diode isolate.
Door Trigger Negative Wire Location: At BCM, C2, Pins 79 And 48. The BCM (body control module) is located in the drivers kick panel. Connector 1 is white, and on top with plug towards the front of the vehicle, connector 2 is white, and on top with plug towards the rear of vehicle. Connector 3 is black and at the bottom.

Dome Light Supervision Wire (-): Tan
Dome Light Supervision Wire Location: At BCM, C2, Pin 48. The BCM (body control module) is located in the drivers kick panel. Connector 1 is white, and on top with plug towards the front of the vehicle, connector 2 is white, and on top with plug towards the rear of vehicle. Connector 3 is black and at the bottom.

Trunk Release Positive Wire (+): Yellow/Red (The rear of the convertible top must be unlatched and folded forward before using the trunk release.)
Trunk Release Positive Wire Location: At Relay Behind Glovebox

Sliding Power Door Wire: N/A
Sliding Power Door Wire Location: N/A

Horn Negative Wire (-): Black/Red
Horn Negative Wire Location: At BCM, C1, Pin 17. The BCM (body control module) is located in the drivers kick panel. Connector 1 is white, and on top with plug towards the front of the vehicle, connector 2 is white, and on top with plug towards the rear of vehicle. Connector 3 is black and at the bottom.

Tachometer Wire Negative Wire (-): Gray/Light Blue
Tachometer Wire Negative Wire Location: At Tach On Column, Pin 1

Wait To Start Wire: N/A
Wait To Start Location: N/A

Brake Light Positive Wire (+): White/Tan
Brake Light Positive Wire Location: At Steering Column Harness

Factory Alarm Disarm Wire (-): Light Green/Black (A negative thru a 663 ohm resistor will disarm the factory security without unlocking the doors.)
Factory Alarm Disarm Wire Location: At BCM. C2, Pin 45. The BCM (body control module) is located in the drivers kick panel. Connector 1 is white, and on top with plug towards the front of the vehicle, connector 2 is white, and on top with plug towards the rear of vehicle. Connector 3 is black and at the bottom.

Factory Anti-Theft System: Chrysler Sentry Key (Gray Key Only)
Factory Anti-Theft System Location: Transponder At Ignition Switch Tumbler

The 2002 Chrysler Prowler alarm wire color and location information above is updated as it is submitted by the Modified Life community.

Leave a Comment

Your email address will not be published. Required fields are marked *