1999 Dodge Durango Car Radio Wiring Diagram

Whether your an expert Dodge Durango mobile electronics installer, Dodge Durango fanatic, or a novice Dodge Durango enthusiast with a 1999 Dodge Durango, a car stereo wiring diagram can save yourself a lot of time. Automotive wiring in a 1999 Dodge Durango vehicles are becoming increasing more difficult to identify due to the installation of more advanced factory oem electronics.

One of the most time consuming tasks with installing an after market car stereo, car radio, satellite radio, xm radio, car speakers, tweeters, car subwoofer, crossovers, audio equalizer, car amplifier, mobile amp, car amplifier, mp3 player, ipod or any car audio electronics is identifying the correct color car audio wires for your 1999 Dodge Durango.

The Modified Life staff has taken all its Dodge Durango car radio wiring diagrams, Dodge Durango car audio wiring diagrams, Dodge Durango car stereo wiring diagrams, Dodge Durango car radio wiring schematics, Dodge Durango car wiring diagrams and cataloged them online for use by our visitors for free. Our automotive wiring diagrams allow you to enjoy your new mobile electronics rather than spend countless hours trying to figure out which wires goes to which 1999 Dodge Durango part or component.

Feel free to use any Dodge Durango car stereo wiring diagram that is listed on Modified Life but keep in mind that all information here is provided “as is” without any warranty of any kind and most of the car audio wiring diagrams listed on our enthusiast website are submitted by the Modified Life community. Use of the Dodge Durango wiring information is at your own risk. Always verify all wires, wire colors and diagrams before applying any information found here to your 1999 Dodge Durango.

Questions

If you have any questions pertaining to the audio system in the 1999 Dodge Durango, please feel free to post it at the bottom of this page and either we’ll do our best to find you the information you need or hopefully someone in the Modified Life community will have the information you’re looking for.

Request a Car Stereo Wiring Diagram

If you can’t find a particular car audio wire diagram on Modified Life, please feel free to post a car radio wiring diagram request at the bottom of this page and we’ll do our best to find you the diagram or schematic you need for your mobile audio installation.

Adding More Information

If you would like to help the Modified Life community by adding any missing information or adding a new car audio wire diagram to our resource, please feel free to post it at the bottom of this page.

1999 Dodge Durango Car Radio Wiring Diagram

Car Radio Battery Constant 12v+ Wire: Red/Blue
Car Radio Accessory Switched 12v+ Wire: Red/White
Car Radio Ground Wire: N/A
Car Radio Illumination Wire: Black/Yellow
Car Stereo Dimmer Wire: Orange
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: Green
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: 6 1/2″ Speakers
Car Audio Front Speakers Location: Doors
Left Front Speaker Positive Wire (+): Dark Green
Left Front Speaker Negative Wire (-): Brown/Red
Right Front Speaker Positive Wire (+): Brown/Yellow
Right Front Speaker Negative Wire (-): Brown/Light Blue
Car Audio Rear Speakers Size: 6 1/2″ Speakers
Car Audio Rear Speakers Location: Rear Doors
Left Rear Speaker Positive Wire (+): White
Left Rear Speaker Negative Wire (-): Dark Blue/Red
Right Rear Speaker Positive Wire (+): Brown/White
Right Rear Speaker Negative Wire (-): Brown/Orange

Make Your Dodge Durango Car Stereo Installation Easy with these Products

19 Comments

  • Reply Annette Cooper December 5, 2008 at 2:33 pm

    how do i remove the factory speakers in my 1999 dodge durango, what size are they and are they 2 way or 3 way? can you give me any information on the factory amp?

  • Reply Darrick December 19, 2008 at 2:07 am

    Im putting a new cd player in my 1999 Dodge Durango I have everything hooked up the power comes on but im not getting any sound out of the speakers is there something I need to do to get them to work

  • Reply ModifiedLife December 22, 2008 at 10:39 pm

    Darrick, your vehicle may have a factory amplifier that needs to be turned on by your after market radio. The car stereo amplifier trigger wire has to be wired up to turn on your factory amplifier. Unfortunately, we don’t have this information but maybe someone from the Modified Life community can post that information here. Hope this helps. Good luck.

  • Reply ModifiedLife January 2, 2009 at 5:55 pm

    Darrick, after making the connections above, try using the left over green wire and hook up your amp trigger wire to it. This wire should turn on your factory amp to produce sound. Hope this helps. Good luck.

  • Reply Lee Nelson January 11, 2009 at 8:06 pm

    I’m having the same problem but what left over green wire? I have white 2 wire connector left over (purple and white/blk stripe) and a black brown strpe wire left over after using the after market harness. which wire is the amp turn on for the factory system?

  • Reply phillip March 21, 2009 at 9:00 pm

    where is the speed sensor wire for GPS hook up?

  • Reply ModifiedLife March 24, 2009 at 12:09 am

    Philip, the speed sensor wire for your 1999 Dodge Durango is located at the PCM. The PCM is located inside the passenger side front fender. Use the White/Orange wire located at pin 27 in the PCM wiring harness. Hope this helps. Good luck.

  • Reply Earl April 12, 2009 at 12:04 am

    The Blue wire….. Power antena/amp triger
    happy volume control

  • Reply ModifiedLife April 17, 2009 at 8:38 pm

    Earl, thanks for the car stereo wiring information contribution.

  • Reply dooby July 25, 2009 at 10:59 pm

    i just installed an aftermarket cd player in my 99 dodge durango, my problem is that i cant get any power to turn it on. The cd player worked in my last car, but i cant figure out the problem with this. The factory ground wire was different from what i was used to seeing, could this be the problem and how do you fix it?

  • Reply ModifiedLife August 5, 2009 at 1:38 am

    Dooby, its probably a grounding issue. We advise you ground the radio on the vehicle chassis. Hope this helps. Good luck with your radio install.

  • Reply myko August 6, 2009 at 2:14 pm

    i tried to install a aftermarket cd player in a 99 durango slt (w infinity) it turnded on just fine but i could not get any sound. is there a harness for 99 durangos with a factory amp?

  • Reply jefferson23 January 13, 2011 at 1:59 pm

    i have a 99 dodge ram. i pulled the factory radio out and put an aftermarket kenwood headunit in. all the wiring is hooked up right but it wont play sound.

  • Reply ModifiedLife January 18, 2011 at 3:40 am

    Jefferson23, first double check ALL your fuses and make sure ALL your fuses are good. You can do this by using an Automotive Fuse Tester and making sure all of your fuses are not blown. If all of your fuses are good, your 1999 Dodge Ram may have a factory amplifier that needs to be turned on by your after market radio. The car stereo amplifier trigger wire has to be wired up to turn on your factory amplifier to output sound from your speakers. Hope this points you in the right direction. Good luck with your 1999 Dodge Ram stereo installation.

  • Reply Eddy April 5, 2011 at 3:02 am

    1999 Dodge Durango Car Radio with factory amplifier. There is no left over green wire to hook up, only a white one. But there is no response from the Amp. What can i do to start the Amp?

  • Reply Ryan June 30, 2011 at 3:21 pm

    I have a 99 Dodge durango and i installed an aftermarket cd player but it will only play through the radio and not read any cds but the cd player worked fine in my old car.

  • Reply Daniel January 27, 2012 at 3:42 pm

    I am installing Kenwood KDC-BT848U in my 1999 dodge Durango. An was wondering what wires I hook to the dimmer wire on my deck. There is only one wire comin from the Durango but two from the head unit? Any help would be greatly appreciated.

  • Reply Richard March 29, 2012 at 11:59 pm

    I need help on my 1999 dodge durango. I wired a Sony deck but when I turn the car off the memory ain’t working so what can I do to fix it.

  • Reply ModifiedLife April 10, 2012 at 8:49 pm

    Richard, you may have mixed up the battery constant and accessory switched wires. The battery constant always sends power to the radio to save your radio stations and other audio settings. The accessory switched wire sends power to your radio only when the key is in the ignition and your 1999 Dodge Durango is on. Check your wiring and make sure the correct radio wires are hooked up to the correct wires on your factory harness. Hope this helps. Good luck with your 1999 Dodge Durango radio installation.

  • Leave a Reply

    fifteen − 4 =