1995 Chevrolet Camaro Alarm Wires
Find the right alarm wire colors, locations, and polarity with this 1995 Chevrolet Camaro alarm wiring diagram. This will help you install your car alarm wiring correctly.
Application | Wire Color and Location |
---|---|
Battery Constant 12v+ Positive Wire (+) | Red |
Battery Constant 12v+ Positive Wire Location | Ignition Switch Harness |
Starter Positive Wire (+) | Yellow |
Starter Positive Wire Location | Ignition Switch Harness |
Ignition Positive Wire (+) | Pink |
Ignition Positive Wire Location | Ignition Switch Harness |
Accessory Positive Wire (+) | Orange |
Accessory Positive Wire Location | Ignition Switch Harness |
1995 Chevrolet Camaro Alarm Sensor Wires
Find the right alarm sensor wire colors, locations, and polarity with this 1995 Chevrolet Camaro alarm sensor wire chart. This will help you connect all your car alarm sensors correctly.
Application | Wire Color and Location |
---|---|
Parking Light Positive Wire (+) | Brown |
Parking Light Positive Wire Location | In Drivers Kick Panel, Harness Heading To Rear Of Vehicle |
Power Door Lock Negative Wire (-) | Light Blue (if vehicle does not have a factory keyless entry, use the light blue for lock and the dark blue for unlock (5 wire reverse polarity) the wires are located in either kick panel. You must use the passenger switch as the master switch when testing. For vehicles with factory keyless entry use the red/black for lock and the orange/black for unlock. Both wires are located in the passenger kick panel at the factory keyless entry module. Do not use the orange power wire at this module or the door lock switch power wire to do your door locks. With factory keyless entry the door lock system is also a 5 wire reverse polarity system and you must use the passenger switch as your master switch when testing.) |
Power Door Lock Negative Wire Location | N/A |
Power Door Unlock Negative Wire (-) | Dark Blue (if vehicle does not have a factory keyless entry, use the light blue for lock and the dark blue for unlock (5 wire reverse polarity) the wires are located in either kick panel. You must use the passenger switch as the master switch when testing. For vehicles with factory keyless entry use the red/black for lock and the orange/black for unlock. Both wires are located in the passenger kick panel at the factory keyless entry module. Do not use the orange power wire at this module or the door lock switch power wire to do your door locks. With factory keyless entry the door lock system is also a 5 wire reverse polarity system and you must use the passenger switch as your master switch when testing.) |
Power Door Unlock Negative Wire Location | N/A |
Door Trigger Negative Wire (-) | Gray |
Door Trigger Negative Wire Location | Behind Left Rear Speaker |
Dome Light Supervision Wire | Use Door Trigger, Requires Relay |
Dome Light Supervision Wire Location | N/A |
Trunk Release Positive Wire (+) | Black/White (Requires Relay) |
Trunk Release Positive Wire Location | Low In Passengers Kick Panel |
Horn Negative Wire (-) | Black |
Horn Negative Wire Location | At Black Connector In Steering Column Harness |
Tachometer Wire Negative Wire (-) | White Or Red/Black |
Tachometer Wire Negative Wire Location | At Coil Pack. On V-6 Engines It Is A White Wire At The Left Cylinder Head And On The V-8 Is It A Red/Black At A 4-Pin Plug Passenger Side Valve Cover. |
Brake Light Positive Wire (+) | Light Blue Or Yellow |
Brake Light Positive Wire Location | At Switch Above Brake Pedal |
Factory Alarm Disarm Wire (-) | N/A |
Factory Alarm Disarm Wire Location | N/A |
Factory Anti-Theft System | 2 White Or 1 White And 1 Purple, Wires Are In An Orange Tube |
Factory Anti-Theft System Location | Gm Vats System At Ignition Switch. If Vehicle Is Equipped With Passkey/Vats, Ignition Key Will Have A Little Chip On The Steel Shaft Of The Key That Can Be Seen. |
Feel free to use any 1995 Chevrolet Camaro alarm wiring diagram that is listed here but keep in mind that all information here is provided as is without any warranty of any kind. Use of this 1995 Chevrolet Camaro car alarm wire chart is at your own risk. Always verify all wires, wire colors and connection points before applying any information found here to your 1995 Chevrolet Camaro.
3 thoughts on “1995 Chevrolet Camaro Car Alarm Wiring Diagram”
when searching for the power unlock and lock wires, i found a total of like 4 blue wires int he kick panel, how do i figure out which wires i need
Foxy, any of the problems you mentioned could be the problem. We have a couple of preliminary questions:
1. When you start your car, does your car crank, start and run for a couple of seconds/minutes?
2. When you start your car, does your car crank but not run?
Let us know and we’ll do our best to help you out.
Is it possible to bypass the factory anti theft on a 1995 camaro? My sons car will not stay running. The security light is on. It starts then bogs out. We checked the chip in the key it is good. We were first told it could be the two wires on the ignition cylinder may have broken. Then we were told it could possible be the anti theft module burned up. My son does not have a lot of money to fix the car so we are trying to narrow the problem down and do as much as we can ourselves considering the local chevy dealer told us that it would be 85 to diagnos it and 500+ to replace the cyclinder. They would not quote a price for the anti theft module so I am sure that is very expensive. Please help.